Tacoma World Forums

Tacoma World Forums (http://www.tacomaworld.com/forum/)
-   2nd Gen. Tacomas (http://www.tacomaworld.com/forum/2nd-gen-tacomas/)
-   -   Aux Fuse Box Panel Needs Advice... (http://www.tacomaworld.com/forum/2nd-gen-tacomas/255557-aux-fuse-box-panel-needs-advice.html)

Denk 12-30-2012 01:26 PM

Aux Fuse Box Panel Needs Advice...
 
I've completed cutting/bending the panel and fabbing the main support, however, the back edge is still a bit flimsy. Do you think it would be a good idea to use the lower bolt on the master cylinder?

Panel - 22ga steel sheet (probably should've gone 16ga on this, oh well...)
Main Support - 1/8" steel rod

Here's a wide shot showing the bolt I'd like to use...

http://i4.photobucket.com/albums/y10...a/IMG_2910.jpg

This is the main support, utilizing a bolt in the main fuse box mount...

http://i4.photobucket.com/albums/y10...a/IMG_2912.jpg

General shot of the panel. I still need to cut out the red circles for routing wires... or do you think I'd be better off cutting slots or smaller holes to maintain integrity?

http://i4.photobucket.com/albums/y10...a/IMG_2911.jpg

Thanks for the help. This place is invaluable!


All times are GMT -7. The time now is 05:58 PM.