04 Tacoma turned Buggy

suspension:
front:
- 3.5" over control arms
-fabricated spindles (to hold the tundra unit bearings)
-2.0 bumps
-heim steering
-11x12 ps cooler


Rear:
-all pro 5" lift springs mounted sua
-12”shackle
-fox 14" bypass shocks
-limit straps
-rough stuff high clearance u-bolt plate

engine/trans:
-Greddy turbo (roughly equivalent to a 2860r)
-non-intercooled
-AEM water meth
-AEM fuel pump
-AEM fic6
-3" exhaust
-BIG trans cooler, fluid thermostat, in-line filter, thermostatically controlled fan
-rear mounted rad, fans off c5 vett
-coolant filter
-heavily thinned factory wiring
-140 amp alternator

brakes:
front:
-tundra calipers and rotors
-stainless steel braided brake lines
rear:
-stainless steel braided brake lines
-willwood brake proportioning valve
-willwood 2lb residual pressure valve
-prelude front calipers
-tacoma front rotors

drivetrain:
rear:
-second gen 8" rear axle (e-locker)
-nitro 5.29 gears
front:
-second gen tundra 9" diff, cv, and unit bearings
-nitro 5.29
-arb locker
-cromo a.d.d. shaft 140mm shorter then stock, 1.9” OD, integrated clutch gear

miscellaneous:
-37x12.5x17 cooper stt pros ,
-emgo 12k winch

 

You should cut those bolts to a shorter length.

 

Nice truck, seen the kM2's had to take a look.

 

nice build so far. more pics of the custom fabrication?

 

Nice sliders i like them, nice build so far

 

just ordered my fox 14" 2 tube bypass shocks from down south motor sports.thought that would be a good start for mid travel. now i just need to figure out how i want to build my bed cadge. any ideas, so far im thinking that im gona have to cut up my tool box to make room

 

got my shocks today some 14"stroke 2"body 2 tube fox bypass shocks...should go nice with mid travel

 

Looks good!

 

thanks

 

sweet truck!pics of how it sits with the bed on?

have fiberglass?

 

sleeper!

 

i think that im now deserving of this decal. hopefully some day ill de able to put a king and a camburg one next to it when i do the front

 

few new parts

eagle eye 130 watt lights

poly bushings

 

i got this nice ding in the door while wheeling yesterday.no idea what i hit just found it when i got home. good thing i have sliders otherwise it might have been allot worse.

 

where at in mo are you?

 

ashland. just south of como

 

the bottom line is the line actually being used for the new high clearance rear bumper


one side down! i made the cut angled like it is so i don't stand out to much and it should still work the same, maybe better cause ill be able to kinda slide off obstacles. side note but i think it makes my truck look faster.

 

lined every thing up and tacking it in to place.





im pretty happy with how it turned out.ill test it out tomorrow and see if it was worth cutting up my truck

 

looks good