So what is everyone running in the rear

100% approved by me lol

 

what year is your truck? all i did was space the center support bearing down a little with a few washers on the driveshaft to make sure the angle was correct but thats it and mine is a 02.... edit yours is an 07 it should be the same... should have a slip spline by the rear diff and should be ok

 

2007 ... But I just thought about it that trip will cost me an arm and a leg .. If not some other appendage ... Lol Jk

 

lol send her out for blinker fluid and have a couple buddys help you i can change out my front leafs in the drive way with a hilift jack and a brick and a few tools in 20min lol

 

20 min man you must have a pit crew ... And we already have blinker fluid ... I buy stock in it ... Lol ..

 

^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
This & theres no need to even change U bolts as long as your stockers arent thread stretched too bad, anything under 3" shouldn't need ext. brakelines, no added yokes or shafts w/2 piece drive shaft just need to drop the carrier an inch or so to correct drive angle, no need to shim axle generally with 2 piece shaft..

members 1st gen leafs I rebuilt for about a 3.5" lift...

 

nope i do it by myself lol iv done it so much adding leafs and removing them it have it down to a system i actualy put some dodge dakota rear springs under the front today lol rides smooth! and you need 2015 smart car fender gaskets

 

& a 2nd gen. w/ the TSB springs...

 

is that WD-40 overspray lol

 

So it's kinda late might be a stupid question but your saying just build a new Leaf pack .. Or add to mine .. If I build one I'm just running a four pack ?

 

the only question that is stupid is the question that goes unasked. yea the leafs are arched more than the ones on the tacoma so it will add lift by adding leafs into the pack

 

& a 2nd gen w/TSB springs added 2 chevy springs for 3"

 

Oooh yah ... I see says the blind man... Duh... Thanks guys ..

 

np goodnight

 

Now is that going to be too stiff for my little taco

Last question

 

I've been running 2 Ford springs per side for a year or so & i mean i have beat the shit out of them, hauled in slight excess of half a ton, still have beautiful arc, still have my 3" of lift also...

 

if it is a little stiff remove a taco leaf.. but it shouldnt be they are thin leafs

 

Cool thanks guys ..

 

Yup, you can get all kinds of diff results just by playing with spring quantity/length.... heres one of mine, not quite finished ... minus the WD40..