35's on a 2004

i have a 2004 ext tacoma i want to put 35s on it im going to do a 3 inch lift and a 1 inch body do you think i could fit 35s on there with 2 inch wheel spacers?

 

Sure.

Still have to do a lot of cutting though and trimming. 2" wheel spacers would mean you'd have to trim a lot of the fender out and close to the door mount.

Do some searching. Tons of info on this

 

Be prepared to wear some blades out on your sawsall because u will being using it alot. Most people rub with 35s on a 6" lift some jus imagine it with a 4"

 

Check out boxrocket's build thread. He just put 35's on his with 3" and 1" body.

I myself have 35's on 2". Takes A LOT of cutting to fit 35's on a first gen. Both inner fenders wells have to be tubbed at least 2.5" back in order to not have rubbing. I tubbed mine all the way back to the body mount. Actually...a little bit further


image by Tanner Tucker, on Flickr

 

Adam still rubs. His 35s are just temporary too

 

^is that boxrocket?

 

Yea sorry.

35s are off his LC as he is reprinting his tacoma rims. Says he would rub when offroad and bigger bumps.

Not staying on his truck..yet

 

Yea I remember reading something about that. Wasn't to sure if he was keeping them on there. They look good!

 

I'm sure he will go there at some point. Just not yet.

 

For the OP if its just a street truck the 35's will work with a 3" lift and 1" BL. Still need to trim and do the pinch weld mod but you can run it without tubbing the firewall. I wouldn't use the 2" wheel spacers though

Now if you plan to offroad it, then you'll definitely want to tub the firewall. Mine only rubs at full lock. Haven't rubbed once otherwise in the past two weeks of street driving even through some good bumps

Here's mine

 

That thing sure is purrrrdy!!