Procomp coilovers and rear MX6 shocks

!!SOLD!!

This is a feeler to see if anyone would be interested in the procomp coilcovers and rear MX6 shocks for their 6" lift. They have probably 25k miles on them all on road miles. I'm going to send the coilovers off to procomp to service them first if someone wants to buy them. They will be like new. I'm going to asking $500 shipped in the USA if someone is interested. New this setup was $1000. PM me if your interested.

 

Let me know I might be interested. Thanks

 

I'm only planning on sending them off for service if I can get a committed buyer. I'll pay for the service then once I get them back I'll sell them. I don't want to spend the money to have them serviced and not be able to sell them. So let me know.

 

What's the model number on the coil overs? Can you PM me specs for these? Very interested.

 

Wait these are for a 6" lift?

 

Yes for their 6" db lift.

 

2 questions.... why are u servicing them with only 25k miles on them,, and also what are you going to swith to??/ no busting-balls here,, im asking so I can learn, im new to tacos,, and have a 6 in lift on mine, ... oh sorry one more question, if my pro-comps are worn can they all be re-built or no?? thank you and again im trying to learn ...not being a smart - azz...

 

I'm new too, if you would put these on, would it lift your truck 6"?

 

Well when I took them off one shock looked a little longer than the other actually by a half inch. I called Jeff and he told me that the FJ's used a little longer shaft than the tacos and they must have sent one of those by mistake. Doesn't hurt anything as they have now switched to all the same length. When installed I didn't notice the difference. They are fixing that one and servicing both for me. I decided to switch to the icon coilovers. I needed a little more room for my alignment seeing I'm running spc UCAS. I liked the clearance of the icons better. Stock UCAS should be fine with the pro comps. Hope this helps.

 

What else is needed to complete the 6" of lift? I know these are the shocks from the kit but isn't there crossmembers and other parts?

 

Yes you will need their stage 1 kit. That has all of the hardware for a 6" lift. These shocks that I'm selling are to make a stage 1 into a stage 2. Basically going from a spacer in the front to the coilovers and upgraded rear shocks.

 

That sounds like a good deal but ive read bad reviews on procomp shocks. How was the ride with them?

 

They are a little stiff but if you back them off a few threads they are softer. You may loose 1/2 " of lift in the front but its worth it for ride quality.

 

Do you still have these?

 

No. These sold quite a while back. I had marked the original post as sold when the sold.