Free High Flow Bolt-In Cat for Headers

FREE- pickup ONLY- Lake Forest, CA 92630

I had this on my 2001 3.4L tacoma with JBA headers.

It bolts to the header collector and the factory rear exhaust location

Its a single High Flow Magnaflow Cat

it also has a O2 bung welded in(I had an AFR gauge)

You will need to go to your local autoparts store and get some gaskets, I don't have part numbers for you, i just would dig through their bins of gaskets.

 

You must have headers for this to work

 

Think it would work fine on my 4banger with LCE headers?

 

the ID of the pipe is 2", and the mounting flange is 4.25" center of hole to center of hole. i'm not sure what the LCE flange is, so you'd have to check.

 

I might be interested in this. I have the TRD headers. im a bit confused though. So your saying one end bolts right up to the headers flange? and the other to the muffler pipe flange? What about the 1st cat? My header flange comes down at an angle into the first cat.

 

Ya the JBA header mount is parallel to the ground, so this would NOT work for you.

 

Gotcha, thanks

 

Is that catalytic converter actually for a 1st gen? I'm pretty sure 1st gen headers don't eliminate the first cat.

 

I still got both cats. Lookin to upgrade everything from the header flange to the muffler and o2 sensors.

 

I just got Doug Thorley headers and 2 new cats and that cat wouldn't work on my 04 with out the front cat.