cb radio install in a 2007 tacoma

I have a 2007 toyota tacoma i just bought in feb. heres how i installed my cb radio in my truck.

i put a bored in between passenger seat and console and i ran the power and ground wire into cab through a hole on right side of firewall and ran roof antenna down under left side of cab through a rubber plug and up into cab and over to cb radio.

i am posting some pics to show how i did it.

 

I'm about to finally install mine. I was thinking about going through the firewall too. Seems like just about everyone goes through a grommet in the floorboard.

Any reason you can think not to run the antenna coax through the firewall too? Heat?

 

Here's a write up that another member did for a CB install.
http://www.tacomaworld.com/forum/2nd-gen-tacomas/134082-my-cb-installation-detail.html



This is my install, if you wanted to go stealth:

 

Any heat issues with this setup?

 

This is where I mounted mine as well.

Hey, OP,

Can you get a shot of the power wire coming through the firewall from the inside of the truck?

All that's left of my install is to feed it power and tune it.