2002 Tacoma switch location

I want to put one of the OTRATTW switches in the factory precut areas on my 2002 Tacoma that is right below the ash tray. Does anyone have any pictures or know if any of their switches would work in that area? Is that precut area just have a plug or will I have to cut it out?

Specifically looking at this switch in that location (horizontal).

http://www.otrattw.net/CONTURA-V-BED-LIGHTS-LOWER-LED-INDEPENDENT-V1D1JNNB-PZC59-5TL.html

 

Check out paranoid56 switch plates in the classified section. He makes a 6 switch plate and even a double for the ashtray

 

http://www.tacomaworld.com/forum/1s...5089-6-switch-plate-under-radio-location.html

 

Still have factory radio and don't really plan on replacing it. I might do the ashtray, but really like the little factory spot if its possible.

 

the ottattw switches dont fit that location, you could get some other OEM switches and wire them up how you want and use them. that would be the cleanest way. however, in that location, its kinda hard to use.

 

No way to make their switches work in that spot? I've already bought a horizontal switch from them. Can that spot be cut out bigger?

 

i would need to look again, but i thought the hole was to big. but you can make it work i am sure.

 

Found some useful information, just thought I would share.

These switches with fit fine in the factory precut locations below ashtray.
http://www.dragtimes.com/parts/TOYO...-CAMRY-PU-RAV4-LAND-CRUISER_171002205471.html

Looks like the OTRATTW switches will also work with minor trimming.