Icon setting ?

We have about the same setup, about how much thread do you have showing on each side? I am installing mine tomorrow and just want a base estimate to begin at.

 

Ill measure tonight and report back.

Remember to measure (center of the hub to fender), adjust (jack up the truck, Unlock the screw, turn nut, Lock screw, lower truck) , drive around the block, Measure (center of the hub to fender) Repeat as needed. 23inches = 3 inches of lift.

 

I have an 1.25" on the drivers side and just less than an 1" on the passenger.

 

nice, maybe I'll start there and see where I end up. thanks bud.

 

So how did this all turn out for you? Did you get it all done yet? Have any pictures?

 

Yeah mine is set, I need to measure tomorrow I can't remember but to get mine to 3" my settings are about .25" higher than the above measurements. I need to grab some pics. I think I might lower it cause it rides a bit rough. My OME setup was smoother.

 

I have 700 lb coil with driver side at 1.5" and passenger at 1.25" for a 3 in lift. Rides a little stiffer. Not sure if from the preload or the heaver coils however.
Driver
Passenger