Installing 2012 stock radio in a pre-2012

I ordered those pins as well
I've been looking at how to wire up the USB port right now

 

Those pins were a tight fit but they worked!!

Only connections left are ignition power (works fine without it hooked up), FM/AM, GPS, and SAT antennas, and speed signal for the amplifier. Also need to get a different radio surround. Dealer accidentally ordered the one for a 2wd. The climate controls fit fine in the new surround. The radio surround is swappable between the old and new styles. The radio came with an entune account so all that works. Love having pandora, Bluetooth iPod, and iheartradio available on the touchscreen.

 

Sick, how much was the surround?
Looks good man!! Hopefully I can get the camera working and the USB port to hook up my iPhone straight

 

Surround was expensive, but looks good. My old surround was messed up from the previous owner anyways.

 

Gotcha, ya it's in the high $200s

Cool, now they those pins work, I just have to wait for mine that should come in today

 

Got SiriusXM radio working today. Found a male to male satellite radio cable from Toyota. Temp installed right now but looks like the length is perfect to go from the radio to the drivers kick panel. I don't know how it's still working, the trial period is only supposed to be 3 months and it's been at least 4 since I bought the radio. Not complaining though.

 

I need to check the antenna plug tomorrow for you...forgot about it

 

so this is a complicated swap- but what about entune/jbl to non entune/non jbl for a 2012 unit? as complicated or less so? any tips on this type of swap?
thanks

 

Both are a bit complex especially an entune to a non jbl Tacoma...
Dibble is swapping then entune unit to a 2010 jbl Tacoma
And I'm swapping a non entune to a non jbl 2008

I like a challenge

 

http://www.tacomaworld.com/forum/southern-california/257687-looking-2013-tacoma.html#post6262736

^^^if you have one, and are local post in that thread...just need to double check some schematics I am making so other people can accomplish this as well
Thanks

 

What questions do you have? I'm almost done with my write up and have mine fully working. I've studied the schematics and understand them well.

Here's what I have so far. It is NOT complete. Maybe it'll help you out.
https://www.dropbox.com/s/162e7d9yzrqwfr2/ENTUNE WRITE-UP.pdf

 

See the thing is that I don't have the cam and I want to check the exact connection in the back...maybe I'm missing something (since both radios are different)

And my truck didnt come with a back up cam so I'm installing that from scratch anyways so might as well check how Toyota connected it under the foot panel and stuff

Oh ya and to test my USB plug

 

Actually I'm putting the entune in a non-JBL truck. Little bit more work but worth it so far. I like the challenge too!

 

Jerez, were you able to find the part number or source for the USB jack harness?

 

Negative...gave up on this project for a 2-3 months, need to finish up some other "stuff" on it that's been pending for a while now

 

At the point now where I'll probably just make my own USB adapter cable.

 

So perhaps this would be almost plug n play for my 2011 JBL Tacoma. Its totally different then 2010 and earlier.

 

Negative, same truck same stuff

 

So how hard would it be to swap a 2013 entune unit into a 2009 JBL equipped truck? Love the look of the new entune and yours is looking great.

 

Weird cause the XM radio is inside the deck unlike some older trucks and iPod adapters don't work either. Something has to be different.