Need help with sub wiring!

Hi all, so first I will say that I have searched for what felt like hours and either I'm blind or I just couldn't find the answer I was looking for.

So, I'm planning on putting 2 2 ohm DVC subs behind the rear seats in my 2015 double cab but I can't seem to wrap my head around how to wire them to a monoblock amp since they will be in separate chambers on either side of the truck. I would like to wire them to a final load of 2 ohms, so would this wiring work or am I just making a fool of myself and doing something completely wrong? I know it isn't the cleanest look but I'd rather not go drilling holes in the box just to wire both subs together if they are not necessary. Also if the amp has 2+ and 2- terminals like I have drawn, would that affect the wiring in any way? Or would I be better off getting a mono with just 1+ and 1- terminal? I know they are not 2 separate outputs and something is done internally for easier wiring of multiple subs, but my knowledge of wiring is next to none lol. Sorry in advance for the terrible drawing lol, I just sketched something up on surface pro 2 really quick for this post.

 

I believe that's what your looking for. That's how I'm hooking up my subs when my box comes in. Mr marv approved it for my setup which is dual idq10 d2 v4 subs powered by a jl audio jx1000 amp

 

Ok thanks! I just wasn't sure about the wiring going from the terminal cups to the second sub since everything I saw was wiring from the first sub directly to the second.