After long debates I have decided to sell my baby. It is a 1990 4runner 5speed 4x4 that I have dumped my heart and wallet into. Here's a list of some parts and upgrades.
300mi on newly rebuilt engine 3vze (not the best but runs like a top)
-rebuild parts all from LCEngineering
-all bearings and seals replaced
-ARP head studs (to help with the 3vze head gasket problems)
-LCE headers (drops the crossover under the trans also helps the head gasket
problem, keeps the rear cylinders from being overheated)
-full Magnaflow exhaust from headers back (has test pipe in place of cat., easy
to bolt a cat right back in place)
-new rear axle seals
-new torsion bar adjusting bolts and nuts
-33x12.5x15 Goodyear MTR with kevlar (about 500-1000mi on them) has 5 so
you have the same tire and rim for spare.
-EGR has been deleted
-custom front bumper, rock sliders and roof rack
-battery has been relocated to rear of truck
-ProComp 3.5" rear lift springs
-all new tie rod ends (inner and outer)
-all new ball joints (upper and lower)
-previous owner put 2" ball joint spacers in front and jacked up torsion bars so
it had to be lowered back down a little when I had the alignment done.....
wasn't a big deal to me because I was planning on doing SAS but ran out of
Runs and drives good and the headers gave the 3slow a good bit more power
I have more than $7k into it and am asking $5000 but price is always negotiable and this would make a great truck for any project platform also open to trades let me know what u got
You can contact me through email firstname.lastname@example.org and if you want to call email me and I will give you my # and I can send more pics if needed.