Show off your CBI OFFROAD ARMOR!!!

Thanks for sharing and we are glad your bumper did its job and saved your bed! Hope everyone was okay!

 

Very nice! Thanks for sharing and we love the new additions!

 

Thank you Nathan and the rest of the CBI Team. The truck is fantastic and I could not of done it without you.
Nathan you know darn well I'll be calling you again and again. There is more to do . Thanks again for all the advice, hard work, great service and the strippers.

Bumper to Bumper CBI

 

Looks good, haven't seen much info on their skid plates yet. Was an exhaust reroute required for the mid / transfer case skid or does it have enough clearance to fit over the stock exhaust?

 

No rerouting of the exhaust needed for these skid plates!

 

Check out this awesome video of our Moab 2.0 being built

http://youtu.be/awuvppiQtBI

 

Link is incomplete. I want to see this video!

Hope all is well at the shop! Sliders and rear bumper are treating me well 2 years later

Also, awesome rig Chris!!! Need to make a point to get out together next wheeling season

 

Works for me okay on Chrome.

 

Works now

 

how much does the moab 2.0 weigh>? are the OME 887 coils good enough for the weight? or 886?

 

The front bumper will be between 100 lbs to 125 lbs depending on the grill guard you go with if you get it. Honestly the correct front springs for "you" may be hard to say depending on what you like. I like a less stiff ride so I'm willing to put up with a little more droop but that is just me. If you go with the Moab 2.0 with just the center grill guard you will be around 112 lbs total for the bumper. Don't forget to add the weight of your winch if you are going to carry one!

Let us know if we can help with anything else.

 

Sub'ed.

I've been drooling over a Bushmaster 2.0 rear bumper for my Tacoma for ages. Really nice work fellas.

Cheers,

Salt

 

Tag

 

Moab. Put the factory fogs in today. Big thanks to Nathan for helping me out on the phone. One note for you though- the hardware included for the fog brackets isn't long enough to attach the bracket to the fog with all the adjustment hardware removed. I had to use the factory adjustment screws. Has a little bit of play in the light, so I may wrap some pressure tape around the fog housings just to add cushion.

 

Nice rig.
Why is the spare mount angled?

 

The hi-lift mounts under the tire so that is the reason for the angled tire mount. We also offer a vertical tire mount for those not wanting their jack on the swing arm.

 

Gotcha, thanks

Looks like some of your pics are not showing up in this thread.. just fyi

 

anynone have the hybrid front bumper for 05-11? I want to see some better pics of it.

 

Here are quite a few pictures. Email us if you need any more!

 

Thanks, that bumper is beautiful! the pictures from your website are just a little small to see all the details. Also i'm not sure if its my computer or what but the installation guide for the hybrid bumper doesn't load