What stuff do you use to take the TRD decal off the bed that will not scratch?

Lookin for something that is safe to use on the paint

 

Wd40

 

I have heard great things about GooGone. They sell it at most home improvement places. If that doesn't work lighter fluid matches and steel wool should finish things up lol.

 

what I did was I used a hair dryer on it to melt the adhesive then slowly peeled the decal off. Then for the stuff left over I used goo gone and it got it all

 

i just used a heat gun and all the glue was gone with the sticker so i didnt have to worry about it but ive heard good stuff about goo gone, but i highly recommend using a heat gun or hair dryer to get most of the glue off along with the sticker

 

X2

I did this with the body side moldings on my Ram which had feded and were an eyesore. Worked good, couldn't tell a difference after but it took a lot of time and elbow grease.

 

X2.

 

wd40 has aalways done wonders for getting sticky stuff off for me

 

goo gone FTMFW

 

Worked like a charm for me when I tried it!

 

make sure you dont use too much force when getting the goop off that is left from the sticker, or else you will scratch the f**k out of your paint.

i recommend goo gone and a microfiber cloth once you get the label off... and a good coat of wax afterwards

 

This is exactly what I did to get the stickers off my motorcycle. Just take your time and it will work GREAT!

 

I used:

1. Heat gun on low
2. Pull decal off
3. Rubber eraser wheel
4. Clay bar
5. Swirl mark remover
6. Coat of wax.

 

NOT GOOF-OFF!!!!!!!!!!!

 

goof off will strip the clear coat

 

This ^^^^

 

I tested both Goo Gone and WD40 when I removed my decals and WD40 seemed to work a little better for me.

 

I haven't done it personally but I hear pressure washers work great!! If not googone

 

Sunshine and a medical adhesive remover pad. After a wash, claybar, and wax, there was no sign of the sticker.

 

id try it on my brand new truck, car wash pressure washer, worked good on my last truck!