unused switch locations

i want to get some aftermarket fog lights and my tacoma didnt come with stock fog lights. i was wondering how u pop off those plastic tabs that are in the spot where the stock fog light switch is..theyre on the far left of the dash and these 3 empty spots. any idea how to get them off without ruining anything??

 

You have to pull dash apart to pop them out.
Here's how you remove them for a 1st Gen
It's easy though.

1. Remove the 4 10mm bolts on the panel below your steering
2. Remove the screw on the panel
3. Pull off your AC knobs
4. Pop off AC faceplate using a small flat head screwdriver
5. Two screws, one on left..one on right where your AC controller is
6. Pull out your change holder, remove screw behind that.
7. Pull right below your upper vent..and the entire bezel will pop off.
8. Next pull on your faceplate where your ignition is..will pop off
9. Use a stubby phillips to undo the 2 bolts on your cluster bezel(they are above your cluster under the top of the dash)
10. Pop off the bezel...disconnect hazard circuit
11. Wiggle faceplate out..and you can see the switch pieces just 'pop' out

 

Pretty sure you just pop out the blanks on the 2nd gens

The OP has an '11

 

Mixed messages here , but lots just pop them out carefully

http://www.tacomaworld.com/forum/2n...-upper-switch-blanks-left-steering-wheel.html

 

Oh, shoulda read his profile information!
That's why I hate when people don't list it as visible..or list it in the thread


I never mess with the 2nd Gen, father likes stock shit! So I wouldn't know anything about 2nd Gens

 

It is listed under his username

 

Drop and Pop!!!

 

It wasn't earlier

 

It was when I posted 3 minutes after your first post

 

Well it didn't show up for me, some sort of page malfunction

I see it now though

 

thanks guys.. they do pop right out and although u cant reach it by hand, i can easily feed a wire thru the open switch spot down and behind the dash. thanks alot guys!!!