http://www.tacomaworld.com/forum Discussion of all things technical related to the Tacoma, including wiring, error codes, etc. en Fri, 20 Nov 2009 23:07:48 GMT vBulletin 60 http://www.tacomaworld.com/forum/images/misc/rss.jpg http://www.tacomaworld.com/forum http://www.tacomaworld.com/forum/technical-chat/61729-o6-trd-tacoma-no-start-help.html Fri, 20 Nov 2009 21:07:56 GMT hey guys my 06 trd 4x4 v6 nas been sitting for 7 months and wont start,i hve fuel presure and spark for about 6 seconds or until it almost starts and... hey guys my 06 trd 4x4 v6 nas been sitting for 7 months and wont start,i hve fuel presure and spark for about 6 seconds or until it almost starts and then spark goes away ,anybody else had this proble any help would be gr8t thanx ]]> Technical Chat PMART http://www.tacomaworld.com/forum/technical-chat/61729-o6-trd-tacoma-no-start-help.html http://www.tacomaworld.com/forum/technical-chat/61677-dead-accelerator.html Fri, 20 Nov 2009 14:59:32 GMT I'm curious if anyone has / is experiencing this odd symptom. I have an 09 Tacoma TRD Off Road 4.0 V6. Occasionally, upon putting the truck in drive my gas pedal behaves "dead". In other words, it is not causing the engine to increase power and move the truck forward. Instead, I sit there and continue to slowly push the pedal and then all of a sudden it "takes off". Now, the time is very little, maybe a second or two. My dealer said this is due to the transmission not being up to temp and that the computer senses this and does not allow acceleration. But this happens randomly, when cold or up to temp. Any ideas? ]]> Technical Chat rocktoy09 http://www.tacomaworld.com/forum/technical-chat/61677-dead-accelerator.html http://www.tacomaworld.com/forum/technical-chat/61611-cabin-air-filter.html Fri, 20 Nov 2009 02:03:42 GMT I think theres something wrong with my air filter.. I smell strange odor coming from the cabin, i can only smell it when the car is running.. Found... I think theres something wrong with my air filter.. I smell strange odor coming from the cabin, i can only smell it when the car is running.. Found this video on the net about how to replace cabin air filter, is this any good? can i follow it? ]]> Technical Chat daviddrift http://www.tacomaworld.com/forum/technical-chat/61611-cabin-air-filter.html http://www.tacomaworld.com/forum/technical-chat/61604-cabin-air-filter-problems.html Fri, 20 Nov 2009 01:23:31 GMT Has anyone experienced problems with leafs getting into the cabin filter and making noises by getting into the blower motor. Has anyone experienced problems with leafs getting into the cabin filter and making noises by getting into the blower motor. ]]> Technical Chat mickeyroar http://www.tacomaworld.com/forum/technical-chat/61604-cabin-air-filter-problems.html http://www.tacomaworld.com/forum/technical-chat/61495-speedometer-reprogram-after-bigger-tires.html Thu, 19 Nov 2009 06:13:39 GMT This I am sure has been discussed I just couldn't find it. What are guys doing about their speedometers being off after installing bigger tires/rims? I know some vehicles can get the ECU reflashed for it, what about Tacomas? ]]> Technical Chat nolanspawn http://www.tacomaworld.com/forum/technical-chat/61495-speedometer-reprogram-after-bigger-tires.html http://www.tacomaworld.com/forum/technical-chat/61453-clutch-break.html Thu, 19 Nov 2009 02:26:38 GMT I finally installed my clutch. but it is extremely sensative. like i cant even emphasize that enough. Did i do something wrong or will it loosen up... I finally installed my clutch. but it is extremely sensative. like i cant even emphasize that enough. Did i do something wrong or will it loosen up after its broken in a bit. (iv driven for like 1/4 mile to test it so i havnt really broken it in at all) ]]> Technical Chat dylandercole http://www.tacomaworld.com/forum/technical-chat/61453-clutch-break.html http://www.tacomaworld.com/forum/technical-chat/61439-bad-front-acuator.html Thu, 19 Nov 2009 01:32:00 GMT I recently hit my front end behind my front wheels on a concrete block. My axels are fine and transfer case. It wont shift into four wheel drive. ... I recently hit my front end behind my front wheels on a concrete block. My axels are fine and transfer case. It wont shift into four wheel drive. Makes some sort of strange noise when trying to drive in four wheel drive. Could it have to do with my Acuator? ]]> Technical Chat Bachenstien http://www.tacomaworld.com/forum/technical-chat/61439-bad-front-acuator.html http://www.tacomaworld.com/forum/technical-chat/61408-has-anyone-wired-air-horn.html Wed, 18 Nov 2009 22:51:45 GMT Trying to wire up my new air horn, because i think the stock one is wimpy. But cant figure out the wiring. Just wondering if anyone else has done... Trying to wire up my new air horn, because i think the stock one is wimpy. But cant figure out the wiring. Just wondering if anyone else has done this. ]]> Technical Chat toyotadude5 http://www.tacomaworld.com/forum/technical-chat/61408-has-anyone-wired-air-horn.html http://www.tacomaworld.com/forum/technical-chat/61398-good-info-those-weld.html Wed, 18 Nov 2009 21:58:07 GMT http://www.brewracingframes.com/id75.htm Image: http://www.brewracingframes.com/87c8ee40.jpg http://www.brewracingframes.com/id75.htm


]]> Technical Chat chris4x4 http://www.tacomaworld.com/forum/technical-chat/61398-good-info-those-weld.html http://www.tacomaworld.com/forum/technical-chat/61397-cv-boot-problem.html Wed, 18 Nov 2009 21:43:44 GMT So I noticed the clamp that holds the cv boot on the shaft slipped off (not sure how) and some grease spit out from driving (not far) is there a way... So I noticed the clamp that holds the cv boot on the shaft slipped off (not sure how) and some grease spit out from driving (not far) is there a way to get some grease back inside the boot without disassembling the drive axel? thanks for any help on this guys.:) ]]> Technical Chat Tsenekos http://www.tacomaworld.com/forum/technical-chat/61397-cv-boot-problem.html http://www.tacomaworld.com/forum/technical-chat/61395-spark-plug-problems.html Wed, 18 Nov 2009 21:41:26 GMT I changed out my spark plugs the other day and they were gapped correctly and tightened down and everything seems to be correctly hooked up and back... I changed out my spark plugs the other day and they were gapped correctly and tightened down and everything seems to be correctly hooked up and back in place, but my gas mileage since changing them has dropped almost 5 mpg. Any suggestions what this could be? I didn't know if it was possible to just have a bad spark plug, and if so what i could do to figure out which one. Any help is greatly appreciated. ]]> Technical Chat The tacoman http://www.tacomaworld.com/forum/technical-chat/61395-spark-plug-problems.html http://www.tacomaworld.com/forum/technical-chat/61336-trans-slipping.html Wed, 18 Nov 2009 13:42:41 GMT have a 1995½ tacoma 3.4 engine with 5speed trans. It slips in 3rd and 4th. Just after you let the clutch out. then it doesn't slip.
The clutch has 70k on it and suprises me that it would go out this soon. I have personally babied the clutch since I have owned it. Before the clutch got replaced the first time, there was a continuous squeak in the transmission at idle not moving when the clutch was released. When you barely push on the clutch, the squeek went away. well, that squeak came back at about 50k on the clutch that is on now and currently 70k now.

I have read a few threads about the transfer case stuck in Neutral. I don't understand what that would mean. I have checked by putting the truck in 4wd and the truck doesn't slip. Ideas? suggestions, or causes?

skip:eek: ]]> Technical Chat skipster01 http://www.tacomaworld.com/forum/technical-chat/61336-trans-slipping.html http://www.tacomaworld.com/forum/technical-chat/61334-02-problems.html Wed, 18 Nov 2009 12:32:33 GMT I got this trouble code on a 01 Tacoma with the 3.4 and 5 speed the code is for the 02 sensor on bank 1 sensor 1. I changed the sensor before the... I got this trouble code on a 01 Tacoma with the 3.4 and 5 speed the code is for the 02 sensor on bank 1 sensor 1. I changed the sensor before the converter with a Denso exact fit 02 sensor. I used a scanner to clear the code and it was fine for a weeks. Then check engine light came back on for the same bank one sensor 1 O2 sensor. Why would this code keep coming back? I did check the wires and they are okay. The truck has 88,000 miles on it. ]]> Technical Chat Auto http://www.tacomaworld.com/forum/technical-chat/61334-02-problems.html http://www.tacomaworld.com/forum/technical-chat/61257-new-rear-springs-crunching.html Tue, 17 Nov 2009 23:35:44 GMT UGG! Well just got new OME springs and shocks put on the truck yesterday and a few bummers... The new shocks are are scratched to hell so I can only... UGG! Well just got new OME springs and shocks put on the truck yesterday and a few bummers... The new shocks are are scratched to hell so I can only assume they were rolling around the floor or were dropped. When you buy new its nice to have it look new at leasy until you mess or scratch it up...

More to the problem ... every time I move about, stop, accellerate, turn, bump I seem to hear some crunching coming from the back. Any thoughts as to the noises? I did not hear anything like them on my other truck when I had it installed... ]]> Technical Chat 2009tacomav6 http://www.tacomaworld.com/forum/technical-chat/61257-new-rear-springs-crunching.html http://www.tacomaworld.com/forum/technical-chat/61164-about-get-my-clutch-changed-what-do-i-need.html Tue, 17 Nov 2009 05:51:55 GMT As some of you may already know...my clutch is shot :( bad as in when i put it into first and let out the clutch, once it is all the way... As some of you may already know...my clutch is shot :(

bad

as in when i put it into first and let out the clutch, once it is all the way out...it feels like its still held in partially

so

of course the dealer wants 1400+ to fix it with all OEM parts too:eek:


so i decided if im gonna have to spend that much money out of pocket (because my Ext. Coverage doesn't cover it) i might as well get a BETTER clutch

so i found this :D
http://www.urdusa.com/product_info.p..._id=1260518982
it is a kit from URD with their Stage 3 Clutch kit and their lightened flywheel for a good price packaged together!

and also a great mechanic who has worked on my previous vehicles who will do the job for about 400 bucks


now, my question is...what else do i need apart from this kit? what should i replace while down there that will help prevent future damage or what NEEDS replacing while down there?

names/part numbers/links would be GREATLY appreciated

thanks you TW's ]]> Technical Chat AlexForbesR6 http://www.tacomaworld.com/forum/technical-chat/61164-about-get-my-clutch-changed-what-do-i-need.html