1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Need advice on cutting/trim ARB Bullbar

Discussion in 'Garage / Workshop' started by TacoTaro, Jan 28, 2014.

  1. Jan 28, 2014 at 8:47 PM
    #1
    TacoTaro

    TacoTaro [OP] Well-Known Member

    Joined:
    Mar 7, 2011
    Member:
    #52517
    Messages:
    269
    Gender:
    Male
    Los Angeles
    Vehicle:
    04 DC 4x4
    King Coilovers, Light Racing UCA, OME Dakar leafs w/ extra leaf and SB10" Bilstein 7100's and a U-bolt flip. 4.56's, eLocker rear, ARB front, Marlin rear bumper, ARB Bull Bar w/ Warn M8000. BAMF Sliders. Manual hub conversion with functioning ABS. Tundra front brakes. Manual hub conversion with functioning ABS. SCS F-5's w/ 255/85 Toyo MT's
    I went from stock 16x7's to 16x8's w/ 4.5 BS and now I'm hitting the bumper on hard compression.

    I need to trim my ARB Bullbar to make more room for my tires. Looks like I need to cut about 2 inches off the back end. I plan to remove the coil over so I can cycle the suspension to get a more precise measurement.

    So how do I cut this thing without messing it up? I'm thinking angle grinder with a cutoff disc then touch up the exposed metal with rustoleum.

    Anyone else have any suggestions or better ideas?
     

Products Discussed in

To Top