Drivers Side Window Switch LED

ok ok yosh take it easy ill do it your way lmao i got the board off already
ill do it in 2 seconds just need to find my soldering gun

 

yosh is a pro at this stuff, Do not make cold solder points or you will have the same issue as the overhead compass I am sure Yosh would agree.

 

just trying to help you out...cause i could see you doing this and one of the joints desoldering b/c of the heat...then your here asking why it didnt work...then you have to take the back off anyways to correct this...which equals twice as long!! all im saying is really just trying ot help you out dude.

also, as JSG said (in not quite pro, but appreciate the props dude!!), make sure you touch the tined iron to the pad and LED, then touch the solder to the pad and let it melt/wic to the joint, otherwise you will get cold joints (again, like JSG said)

 

i know i know i was joking man , thanks a lot i got it all and it worked perfect , and did my shifter lights with one of these http://www.oznium.com/led-modules works perfect!