Mike "Wuzzy121". Rest in peace, brother

Go Back   Tacoma World Forums > Tacoma Garage > Lighting

Notices

fog light removal?

Reply
 
Thread Tools Search this Thread
Old 11-27-2010, 09:21 PM   #1
hawkman [OP] hawkman is offline
Member
hawkman is on a distinguished road
 
hawkman's Avatar
Joined: Mar 2009, #15185
Location: Prairieville La
Gender: Male
Posts: 79
hawkman's Tacoma Gallery
Question fog light removal?

Is it hard to remove the fog lights?
  Reply With Quote
Old 11-27-2010, 09:48 PM   #2
With sufficient thrust, pigs fly just fine.
chris4x4 is one of the sharper tools in the shedchris4x4 is one of the sharper tools in the shedchris4x4 is one of the sharper tools in the shedchris4x4 is one of the sharper tools in the shedchris4x4 is one of the sharper tools in the shedchris4x4 is one of the sharper tools in the shedchris4x4 is one of the sharper tools in the shedchris4x4 is one of the sharper tools in the shedchris4x4 is one of the sharper tools in the shedchris4x4 is one of the sharper tools in the shedchris4x4 is one of the sharper tools in the shed
 
chris4x4's Avatar
Name: FlimFlubberJAM
Joined: May 2008, #6497
Location: Tenoe, AZ
Gender: Male
Posts: 97,473
chris4x4's Tacoma Gallery
Nope.
  Reply With Quote
Old 11-27-2010, 10:02 PM   #3
Senior Member
Nightstr is one of the sharper tools in the shedNightstr is one of the sharper tools in the shedNightstr is one of the sharper tools in the shedNightstr is one of the sharper tools in the shedNightstr is one of the sharper tools in the shedNightstr is one of the sharper tools in the shedNightstr is one of the sharper tools in the shedNightstr is one of the sharper tools in the shedNightstr is one of the sharper tools in the shedNightstr is one of the sharper tools in the shedNightstr is one of the sharper tools in the shed
 
Nightstr's Avatar
Name: Felipe
Joined: Dec 2009, #28125
Location: Sacramento CA
Gender: Male
Posts: 4,438
Nightstr's Tacoma Gallery
It has to round clips in the back of the fogs on each side. Use a flathead screwdriver to push them both in towards the foglight, push the foglight from back and should pop right out.
  Reply With Quote
Old 11-28-2010, 03:26 PM   #5
Senior Member
Chris(NJ) is one of the sharper tools in the shedChris(NJ) is one of the sharper tools in the shedChris(NJ) is one of the sharper tools in the shedChris(NJ) is one of the sharper tools in the shedChris(NJ) is one of the sharper tools in the shedChris(NJ) is one of the sharper tools in the shedChris(NJ) is one of the sharper tools in the shedChris(NJ) is one of the sharper tools in the shedChris(NJ) is one of the sharper tools in the shedChris(NJ) is one of the sharper tools in the shedChris(NJ) is one of the sharper tools in the shed
 
Chris(NJ)'s Avatar
Law Enforcement:
Name: Chris
Joined: Jan 2010, #29777
Location: Usually in Central Jersey
Age: 35
Gender: Male
Posts: 2,712
Chris(NJ)'s Tacoma Gallery
Agreed. Pretty easy.

You'll also have to squeeze the pin that holds the lower section in place. Its a clip that fits over the aiming screw. Just squeeze from both sides and push foward. Then do the side ones.
  Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Similar Threads
Thread Thread Starter Forum Replies Last Post
04 Tacoma Fog Light Retrofit using 02 4runner oem fog lights oscarscrx 1st Gen. Tacomas 6 10-03-2014 08:46 AM
Fog Lights, Fog light switch, cb antenna dbronzo 2nd Gen Tacoma Marketplace 35 11-25-2011 08:34 PM
fog light removal enjm10 2nd Gen. Tacomas 2 07-03-2011 09:51 AM
05+ ARB Bumper with Fog Light cutouts & Fog Lights in GA wmflyfisher Buy / Sell / Trade 5 07-13-2010 11:43 AM
fog light removal help Krusey1011 2nd Gen. Tacomas 4 08-14-2009 03:27 PM


Copyright © 2014 Tacoma Forum. Tacoma World is not owned by, or affiliated with Toyota Motor Corporation.