how to wire up the fx-r?

my question is how did you guys wire up the fx-r high beams to your 1st gen tacoma because i have been looking everywhere and cant seam to find a wiring diagram. pic's would be great if you have them thanks

 

You should have the H4 harness? So you'll have a 3-pronged plug that will plug into you're old headlight plug. That will control high and low beams

 

if you have the same wiring harness the blue/black connects to your ballast and the two high beam wires coming from the projector goes to the red/black wires just stick the prongs into the connector, and then I just wrapped it with electrical tape. I would say contact TRS to confirm but since theyve grown its hard to get a hold of someone.

 

This plug goes from the harness to the solenoid (polarity doesnt matter)



And the plug in the center of the pic is what controls high and low.
The plug with blue, brown and white wires, plugs into the stock headlight plug.

 

Thanks guys prob is i spaced on buying the adapter plug so Im going to hard wire it my self. That's kind of why Im looking for a wiring diagram

 

just give TRS a call. just remember that they're eastern time so they close at 3:00 PM