caribe makaira
Joined:
Feb 13, 2011
Messages:
11,787
Likes Received:
9,000
Trophy Points:
0
Media:
1
Albums:
2
Gender:
Male
Location:
Caribbean, Puerto Rico

caribe makaira

Well-Known Member, Male, from Caribbean, Puerto Rico

    1. Corey C
      Corey C
      Hello sir
      2023 tacoma access cab, no cargo light but I have the toyota OEM bed lights I want my bed lights and Rock lights to come on at the same time with the off/door/on switch.
      Can I just put a splitter connector right before the 5 wire bed light switch or if I need to connect t before the relay some how.
    2. Bronzebeast
      Bronzebeast
      Any idea what the connector for the front camera on a 2024/25 Tacoma would be? I got a Wolfbox digital rear view and it comes with a front bumper camera. Ideally would like to use the oem toyota front camera and wire it in so it can sit in the oem location on the grille. Looks to be a 4pin connector to the Wolfbox camera so hopefully there’s a conversion connector that would work?
    3. ConnorB14
      ConnorB14
      Hey man! Heard you had some good advice on kill switches, I have little experience with wiring but this subject doesn’t seem to be crazy, I have a 2016 sr5 3.5L and can’t seem to find the fuel pump relay with wiring to splice into. I also heard of some people doing it into the starter relay but I can’t find that either, do you have any instructions or advice? Thank you for your time!
    4. Lago271
      Lago271
      Hi Sr greetings best wishes and all is well, im need of your support im currently in the proces of swaping of interior door panel from in 22 to an 05 taco crew cab and on the window master switch all pinouts are different in color and quanty 05 has 12 and new has 13 again all different color and position was hopping you could help me out with order??
      TVM in advance
    5. Braketest2
      Braketest2
      Good Morning Brother!

      I hope all is well with you! I am working on a 2022 4 Runner today and was wondering if you have any access to the pinouts on the front map light overhead console. There is a connector that plugs into the assembly on the driver side of the assembly, and I am looking for a constant power source like the map lights. Thank you, one way, or another sir!
    6. Tacoma__12345678
      Tacoma__12345678
      Hey man I heard you were the guy for wiring. I have a 99 Tacoma 3.4 and the wires pulled out of the plug for the ds62 sensor, I was wonder if you had color detailed diagram for the plug so I can repin it. Thanks
    7. luischin
      luischin
      hey man i am doing a tacoma 2010
      single cab to 3rd gen conversion i have everything installed on the truck just waiting on the hinges for the tailgate but apart from that it’s done my point is do you know the wiring for the powered windows i have the new door panels and switches if you could help me out here it would be appreciated
    8. PatrickO
      PatrickO
      Heard that you would be helpful with wiring. I'm trying to hookup fang style drl/signal lights on my 2024 Tacoma. I have 4 wire on my lights that needs to be wired. Yellow needs to be tied to turn signal, white needs to be tied to low headlights. I want to tap my turn signal lights and headlights. Do you have wiring colors codes for the turn signal sockets (left and right) and the headlight sockets?
      1. caribe makaira
        caribe makaira
        Does your Taco have DRL's as signal or headlights?
        Nov 24, 2024
      2. Rick River
        Rick River
        Hi happy new year!!! I'm also looking for wiring. Just get a kit for DRL+turn signal+position light, but I want to make t-connector from OEM head light low beam (SR5). would like to purchase OEM connector for t junction, so if you could help on the OE part number & wiring diagram that would be highly appreciated!! Thanks
        Dec 31, 2024
    9. Yeeyee85yota4life
      Yeeyee85yota4life
      Hi I'm in need of a detailed wire color diagram for window switches in my 2000 Toyota 4runner sr5 4x4 it's so confusing please can help
      1. caribe makaira
        caribe makaira
        Can't help ya, 2000 4Runner is not on my info lists
        Aug 15, 2024
    10. ToyoTech224
      ToyoTech224
      So can you help me with my wiring. I'd like to know what wires control what and the correct place to have them ran for correct operating procedure.
      - No more Horn
      - Turn Signals are flashing as if they were blown
      - No reverse lights
      - Door Locks don't work but windows do
      - Windshield Wipers won't stop with switch
      - No Cruise Control
      - Fuel gauge reads incorrectly
      - Temp gauge reads incorrectly
    11. 4gnnr
      4gnnr
    12. Rocket23
      Rocket23
      Hey caribe, we talked before I finally got the cargo switch and I am adding the relay. Shortly. My question is about the harness behind the switch. It has no power to any wires. Does the relay have anything to do with the switch power? My fuses are full all good the cargo fuse is 7.5 amp fwiw.
      2019 access cab aftermarket bed lights is what I’m attempting
    13. monoman
      monoman
      Hello, need some help…
      After installing my Pioneer deck, I'm having an issue with the rear camera. It works fine when putting it in reverse but I can't get it to work when I turn it on with the anytime function. ( Shows No signal) Is there a way to connect it to have on all the time when switched on at the deck? Wondering which wires to splice into…thanks.
      1. View previous comments...
      2. monoman
        monoman
        Yes.
        Mar 19, 2023
      3. caribe makaira
        caribe makaira
        It's going to an issue since the OEM camera gets it's "signal" from the reverse wire to the OEM Head Unit. The Pioneer HU allows the view but doesn't sent the signal. You might be missing part of the harness to mate to the Taco from Pioneer.
        Mar 19, 2023
      4. monoman
        monoman
        Hmmm. I’ll have to look into the harness then. Maybe I didn’t hook something up right. Thanks for the info man!
        Mar 19, 2023
    14. TacosEveryTuesday
      TacosEveryTuesday
      Heyy you don’t happen to have any LED under car puddle illumination lights do you?

      Thanks!
    15. comafern
      comafern
      Hey. I installed LEDs but when I tried to install the dome light, I blew the fuse. After replacing the fuse, my map and dome lights won’t cut off unless overhead console switch to OFF. I saw it could be a trace in the circuit board in the overhead console but was wondering if there was something else it could be before trying to repair the overhead console like a relay somewhere that could’ve failed as well? Thanks
      1. View previous comments...
      2. damotoy2021
        damotoy2021
        I have 2021 Toyota Tacoma Trd sport
        Apr 4, 2023
      3. damotoy2021
        Apr 4, 2023
      4. caribe makaira
        caribe makaira
        You'd have to Contact dealer for correct replacement version.
        Apr 4, 2023
    16. acetech77
      acetech77
      Gracias!! will check out..
    17. acetech77
      acetech77
      Afternoon, I was able to obtain the connectors with the schematic you sent me for the front signal lites. (Corsa-Technic) When I get done I will send you picks of the harness. I would like to obtain the connectors for the rear signal lites, do you happen to have the wiring schematic for the rear signal lites?

      Gracias

      GIl
    18. Villegas25
      Villegas25
      Hello, you speak Spanish?
      1. caribe makaira
        Aug 24, 2020
    19. wagmc
      wagmc
      Hey, I hear that you are the schematic king! I need help locating junction box J6 in a 2019 Tacoma TRD OR. Trying to grab a fog light wire that goes there from the switch stalk. Thought it might be easier to get to than the steering column, but I can't find it on any drawings. Do you have any info on J6 location?

      Thanks in advance.

      MW
      1. caribe makaira
        caribe makaira
        The ground you seek is AFTER the switch. It would do you no service to use it for Fog light activation. The blue wire is the one you need to activate the fogs...
        Jul 1, 2020
    20. ReganGTX
      ReganGTX
      Hello,
      I was reading a post today, where you help somebody with the wire diagram for a aftermarket rear differential switch but the post is no longer there just a comment from the user saying thank you for the wiring diagram. I could really use that wiring diagram if you still have it as I am trying to replace my differential switch in my 13 Tacoma.

      Thank you,
      Regan
      1. TRDSport10 likes this.
  • Loading...
  • About

    Gender:
    Male
    Location:
    Caribbean, Puerto Rico
    Vehicle One-Line Description:
    05 PreRunner TRD Offroad AutoTrans
    Vehicle Modifications:
    Hood Struts, My version Fogs always ON, Map & Overhead Light Mod,
    Civil or Military Service:
    Navy
    Civil or Military Service Description:
    AME2_VAW-117 Wallbangers / Night Hawks at NAS Miramar, San Diego, Ca with CAG 11 Aboard USS Enterprise CVN - 65
  • Loading...
  • Loading...
To Top