LSC15's 95 Tacoma 4x4

Go Back   Tacoma World Forums > Tacoma Garage > Performance and Tuning

Notices

PLX Gauge Shroud & Flexpod Not Compatible

Reply
 
Thread Tools Search this Thread Display Modes
Old 07-02-2010, 09:50 PM   #1
SManZ [OP] SManZ is offline
el tráfico más lento se queda derecha
SManZ is one of the sharper tools in the shedSManZ is one of the sharper tools in the shedSManZ is one of the sharper tools in the shedSManZ is one of the sharper tools in the shedSManZ is one of the sharper tools in the shedSManZ is one of the sharper tools in the shedSManZ is one of the sharper tools in the shedSManZ is one of the sharper tools in the shedSManZ is one of the sharper tools in the shedSManZ is one of the sharper tools in the shedSManZ is one of the sharper tools in the shed
 
SManZ's Avatar
Joined: Sep 2009, #22817
Location: Centreville, VA
Age: 31
Gender: Dude
Posts: 1,232
SManZ's Tacoma Gallery
PLX Gauge Shroud & Flexpod Not Compatible

Just a heads up for you guys - the PLX Gauge Shroud and the Flexpod mount are not compatible with the PLX DM-100 gauges.

http://www.urdusa.com/product_info.p...dgm9d3uj8vjib0



When you try to install this, the lower section will hit the mount point for the gauge cup. I cut this section out.



This will still not fit - the DM-100 is barely long enough without the visor to reach the set screws in the Flexpod that hold it in place. When you add the visor, it pushes the DM-100 out a bit more and the set screws will not hold it in the gauge cup.

This is a photo of the hole in the Flexpod for the set screw. You can see the edge of the DM-100 on the right side of the hole. This is with the gauge visor in place. The set screw will not grab onto this.

This is a shot of where the set screws bite into the DM-100 when it is set into the cup without the visor. Its on the very edge to begin with.



I bought it off Amazon but hacked it up already so no returning it. ::shrug:: Life goes on, but hopefully this will save someone else $15. If anyone has any suggestions to get this to work I'm all ears!
  Reply With Quote
Reply


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
Installed a PLX gauge SpaceMonkey 2nd Gen. Tacomas 14 03-11-2013 10:44 PM
PLX Kiwi vs Scan Gauge WV150 2nd Gen. Tacomas 4 01-08-2012 01:06 AM
Are the 2008 Tacoma & 4Runner wheels compatible??? TMASS Wheels & Tires 1 03-22-2011 08:23 PM
Group Buy On FlexPod Gauge Mount Gadget@URD Group Buys 6 12-05-2010 09:41 AM
PLX gauge. virgilus11 Performance and Tuning 4 01-19-2010 05:44 AM


Copyright © 2014 Tacoma Forum. Tacoma World is not owned by, or affiliated with Toyota Motor Corporation.