1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

supercharger???

Discussion in 'Performance and Tuning' started by Unleashed, Apr 15, 2011.

  1. Apr 15, 2011 at 1:37 PM
    #1
    Unleashed

    Unleashed [OP] Member

    Joined:
    Apr 13, 2011
    Member:
    #54886
    Messages:
    14
    Gender:
    Male
    First Name:
    Brian
    North Hills, CA
    Vehicle:
    06 Prerunner
    General Graber at2 tires prerunner bar by fabtech 3inch leveling kit Hid Kit Kc slim lights Tinted tail lights Flat black Headlight housings
    I want to Supercharge my truck and I have been looking around and they are around 4k I don't know how much they charge to install it but I don't think it should be anymore then 1k.
    what do you guys think??
     
  2. Apr 15, 2011 at 1:38 PM
    #2
    Brunes

    Brunes abides.

    Joined:
    May 31, 2008
    Member:
    #7011
    Messages:
    17,562
    Gender:
    Male
    First Name:
    Rotorhead
    Around
    Vehicle:
    08 Red/Graphite and Satin Black
    Inside: Tint, Wet Okole 1/2 Piped Red/Black Covers, Black Weathertech Digital Fit Mats, URD Short Throw w/ TWM Weighted Knob, USA Spec iPod adapter. Outside: 4300K Retro w/ Angel Eyes and Red Shrouds, 5000K Blazer Fog Light Retrofit, Debadge, Bed Locking Handle, Satin Black Rims Performance: TRD/Steigmeier Blower w/ 2.7 Pulley. 668 Injectors and 320 LPH AEM Fuel pump. URD UCON and 7th Injector. DTLT Headers, URD Y-Pipe, Wicked Flow Muffler. Suspension: Both: OME Shocks Front: 886X's and TC UCAs Rear: Dakars Armor: Relentless Front Bumper Relentless High Clearance Rear w/ Tire/Rotopax Swing Out Relentless Front, Mid, and TCase skids BAMF Diff Skid Recovery and Spares: Fullsize Spare Tire 2x2 gal Rotopax 1x1 gal Rotopax 1x1 gal Water Rotopax Warn 9.5XP-S Winch Hi-Lift Extreme 60" Ironman Off-Road Recovery Kit
    Ummm...Do it??
     
  3. Apr 15, 2011 at 1:40 PM
    #3
    yotabeast505

    yotabeast505 The Beast

    Joined:
    Feb 15, 2010
    Member:
    #31432
    Messages:
    1,154
    Gender:
    Male
    First Name:
    David
    NE Hights ABQ NM
    Vehicle:
    THE BEAST
    here we go. Ford 9" rear after breaking 5 sets of gears in the stock yota 8.8, 5.13 gears with a detroit hard locker, 63" chevy leafs and custom hangers, sky's front spring hanger with sky's extream hysteer and PSC hydro assist ram and PSC pump. welded front spyders in the f-550 front dana 60 with warn hubs, pico brake lines and hoses, elecrtic fan, TRD supercharger with URD 2.1 Pully, URD Map-ECU2 and cage built by me. wide band a/f by inovations, lots and lots more...........
    iv installed mine a few times lol its not hard. just buy one with directions and you will be fine... depending on what elevation you are at make sure you know that aslo depending on boost you need fuel injectors or a total engine management... look on URD
     
  4. Apr 15, 2011 at 7:36 PM
    #4
    Yamaha Dave

    Yamaha Dave Well-Known Member

    Joined:
    Mar 27, 2010
    Member:
    #34080
    Messages:
    2,674
    Gender:
    Male
    Most places will charge around $800 for LABOR ONLY. If you want it tuned and dyno tested be prepared to shell out around $90 an hour, plus dyno time which can run about $100-$150 for a few pulls. That's assuming there are no issues.
     

Products Discussed in

To Top