Flowmaster Mufflers 50 Series SUV Performance?

Looking to purchase a Flowmaster 50 series SUV performance muffler.

Has anyone purchased this for 2007 Tacoma v6, 4.0L???

Happy with your purchase? Do you have a stock number, not sure what to get. I want to weld it to the factory pipes.

Thanks for the assist

 

I don't have one yet but looking to get one for Christmas...

Are you looking for just the muffler or are you looking for a kit?

The 50 series comes in a cat-back dual side exit kit also. THat's what I'm shootin for on my 07 4.0L.
http://www.flowmastermufflers.com/p...d=4089&zenid=bcccc28e233b3aa04df4bb93303fcae5

I've found that kit for $354 (cheapest I've found)
http://www.wundercarparts.com/searc...r=Flowmaster&gclid=CPL_jIylopYCFQNfFQodbQxz5w

 

I was thinking of going the cheaper route and just purchase the muff. Just wasn't sure of size/inlet/outlet

 

hey I have the 50 series of my 07 V6 and it sounds really good, but I really like loud trucks so most likely I am going to move to the 40 series. Just go to an exhaust shop you trust and weld in the 50, duals look nice as well. Good luck bro

 

Do you remember the size? 2.5? Thanks

 

Is the offset inlet / center outlet?

 

The inlet/outlet at 2.5 is fine. Most muffler shops can adapt that if its not exactly correct. Look at muffler on the truck currently and see where the inlet and outlet are located on the muffler.

Mine was center-in/center-out and the inlet they said was 2.5 but the outlet was 2.25. Trick trucks did mine and they said that they had to adapt it to the tail pipe but it wasn't any problem or extra cost.

 

yep.....2.5 in and out will work fine.

 

Too cool. Thanks!

 

I have the 50 series. It's a nice sound, just not too loud, if you're looking for something louder go with the 40 series.

 

Is yours the 50 SUV or delta? Is there a difference? curious? Thanks

 

Ended up getting the FM 50 Delta Series with 3.5" output and chrome tip. Sounds awesome... Very happy with my purchase... $200 OTD aint bad...

 

nice!! put up a sound clip and add it to the sound clip compilation thread in the performance/tuning forum when you get a chance!!

 

what was the part number of your flomaster?

 

Not sure. I went to the muffler shop and told them what I wanted... 30 minutes later I was out the door. Like I said, $200 total parts/labor/tax.