Mike "Wuzzy121". Rest in peace, brother

Go Back   Tacoma World Forums > Tacoma Garage > Performance and Tuning

Notices

Wicked Flow with DT longtubes

Reply
 
Thread Tools Search this Thread
Old 05-24-2012, 05:48 PM   #1
Member
Burritos Taco is a glorious beacon of lightBurritos Taco is a glorious beacon of lightBurritos Taco is a glorious beacon of lightBurritos Taco is a glorious beacon of lightBurritos Taco is a glorious beacon of light
Joined: Mar 2012, #75748
Location: North Texas
Age: 27
Gender: Male
Posts: 37
Burritos Taco's Tacoma Gallery
Wicked Flow with DT longtubes

'05 4.0
URD MAF calibrator
KN 63 series
DT Longtubes
2 x 2.5 inch Magnaflow cats
18" Wicked flow muffler 3" pipe
No tip


I currently have p0031 code, after I replace that sensor I will make better videos.

http://www.youtube.com/watch?v=rxzSjkJy60M

http://www.youtube.com/watch?v=b15PkTdsQFw
Attached Thumbnails
Wicked Flow with DT longtubes-imag0282.jpg   Wicked Flow with DT longtubes-imag0287.jpg   Wicked Flow with DT longtubes-imag0288.jpg   Wicked Flow with DT longtubes-imag0291.jpg   Wicked Flow with DT longtubes-imag0290.jpg  

  Reply With Quote
Old 05-24-2012, 06:04 PM   #2
Member
Burritos Taco is a glorious beacon of lightBurritos Taco is a glorious beacon of lightBurritos Taco is a glorious beacon of lightBurritos Taco is a glorious beacon of lightBurritos Taco is a glorious beacon of light
Joined: Mar 2012, #75748
Location: North Texas
Age: 27
Gender: Male
Posts: 37
Burritos Taco's Tacoma Gallery
A couple more pictures of the drivers side headers and the inside of the muffler.
Attached Thumbnails
Wicked Flow with DT longtubes-imag0293.jpg   Wicked Flow with DT longtubes-imag0217.jpg   Wicked Flow with DT longtubes-imag0294.jpg  
  Reply With Quote
Old 05-25-2012, 04:15 PM   #4
Member
Burritos Taco is a glorious beacon of lightBurritos Taco is a glorious beacon of lightBurritos Taco is a glorious beacon of lightBurritos Taco is a glorious beacon of lightBurritos Taco is a glorious beacon of light
Joined: Mar 2012, #75748
Location: North Texas
Age: 27
Gender: Male
Posts: 37
Burritos Taco's Tacoma Gallery
Thanks for the complement Wildlantaco, but it is a little to poppy-high end buzz for me. I will add a resonator to make it quiet, but hopefully it will keep some of the grunt, and let the KN take over for the high end. I love this 4.0 I just don't the buzz I am getting from the straight through exhaust.



I have had trouble with codes, I do have the rear sensors hooked up to the harness loop controller chip device.

I disconnected the battery and replaced the front drivers O2 sensor for the p0031, now it is giving both p0031 and p0051.

I disconnected the battery again and switched the AF heater relay with the fog light relay and nothing changed.

I will go into the DIY shop Tuesday or Wednesday to do plugs and trans/diff/transfer oils and I will check the OHMs then.

I also have the ABS light on, after the bilstien 5100s were installed, I'll re-check the wires and clean the sensors.

These electronics seem to be one thing after another, I understand why so many people on this for like to stick to stock spec.

And thank for the help, I've been lurking the forums for three months, and learned enough to start my truck in the direction that I feel will make it slightly greater than it already is.
  Reply With Quote
Old 05-30-2012, 02:42 PM   #5
Member
Burritos Taco is a glorious beacon of lightBurritos Taco is a glorious beacon of lightBurritos Taco is a glorious beacon of lightBurritos Taco is a glorious beacon of lightBurritos Taco is a glorious beacon of light
Joined: Mar 2012, #75748
Location: North Texas
Age: 27
Gender: Male
Posts: 37
Burritos Taco's Tacoma Gallery
Put a vibrant ultra quiet resonator, 3" about a foot before the muffler.

It has a better sound to it, all of the low notes are still there, took out MOST but not all of the above 2k RPM buzz.

Sorry for the bad video quality, I was on my own this time.

www.youtube.com/watch?v=LRH6qDTCsao

Going to the shop tomorrow to do spark plugs, trans and diff fluids and to try to solve my p0031,p0051 and the ABS light.
  Reply With Quote
Old 05-30-2012, 03:06 PM   #6
Senior Member
Robertgeejr1 is one of the sharper tools in the shedRobertgeejr1 is one of the sharper tools in the shedRobertgeejr1 is one of the sharper tools in the shedRobertgeejr1 is one of the sharper tools in the shedRobertgeejr1 is one of the sharper tools in the shedRobertgeejr1 is one of the sharper tools in the shedRobertgeejr1 is one of the sharper tools in the shedRobertgeejr1 is one of the sharper tools in the shedRobertgeejr1 is one of the sharper tools in the shedRobertgeejr1 is one of the sharper tools in the shedRobertgeejr1 is one of the sharper tools in the shed
 
Robertgeejr1's Avatar
Name: Robert
Joined: Dec 2011, #69167
Location: Aorora, Ill, yeah!
Gender: Male
Posts: 771
Robertgeejr1's Tacoma Gallery
YOU DOG!
I bet that baby winds out like there is no tomorrow!

i know its somewhat diff. but in 2005 I did bbk headers, with the magna cat back, 3" out... but since I was there, I went ahead and put in new o2 sensors, there were 4, and I did not have a prob. sometimes they get knocked around when doing that and that can mess them up. anyway, hope you get it figured out, and enjoy.
and I got them from JEGS, but I got the highproformance header gaskets, and manifold bolts, don't know if you did that but a small leak from reusing the gasket could cause that.
  Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Similar Threads
Thread Thread Starter Forum Replies Last Post
Wicked Flow Exhaust tacoma-uzi Performance and Tuning 171 12-27-2012 12:28 PM
WTB; HEADERS DT LONGTUBES AND A MESH GRILL FOR O5 X-RUNNER Bobby1941 2nd Gen Tacoma Marketplace 0 10-08-2011 08:56 PM
Dynomax Ultra Flow muffler or Wicked Flow sound clips? TacomaGus 2nd Gen. Tacomas 2 06-01-2011 04:19 PM
Wicked Flow Bitches!! Right? J-Bird Performance and Tuning 41 12-19-2010 10:45 PM
GETTING A WICKED FLOW, PLEASE HELP Detective_Dan 2nd Gen. Tacomas 9 08-28-2010 03:10 PM


Copyright © 2014 Tacoma Forum. Tacoma World is not owned by, or affiliated with Toyota Motor Corporation.