Alabama thread!

while your down there go ahead and grab that V8 he has sitting around and some tools so we can do the swap. oh.... grab his fuel filter and pump for me!!!!! gotta be sneaky about the motor though!

 

http://www.hardlinecrawlers.com/forums/index.php?topic=17955.0

Dude didnt put a location, but i'm sure its around the south east.

 

You have probably read this thread but here it is if you havent. It was very informative.

 

I got my eye on you! hahaha

 

Caleb. I believe I just seen ya at pants barn?

 

45 minutes from knoxville

 

yup that was me up there haha had to get some new shorts


so quick question. lift has been great so far but this morning after I got my front end allignment theres been a pretty substantial squeeking from both sides of the front suspension. other than throwin some major ammounts of wd40 on it any suggestions? it didnt start til after I got the allignment this morning

 

put grease in the zerks on the front end.

 

Justin, how is that finger doing?

 

Stanky

 

Ill give it a shot. thanks

 

make sure you have zerk fittings Caleb, my 2wd 4runner didnt have them. It was a sealed drive shaft.

 

^^^ I searched for over an hour looking for mine following a guide on here. Then found that some models do not have them, mine being one of those models.

 

Since it didn't start until after the alignment, I would take it back to them and have THEM figure it out and fix it since it wasn't doing it BEFORE the alignment. That's what I would do.

 

lulz

 

they claim it was there before......... will can testify the other day there was no squeeking. so now i guess Ill just hose everything with wd40 and wait it out then take it to my mechanic if it doesnt go away. ugh

 

Where are you located at? I have my shop in Marion, and I have several guys from TW that come here.

 

he is in hunts vegas

 

I need to hear this sound Caleb, see what your dealing with.

 

Ahh. Too far for my shop. sorry.