New Mexico Owners BS Thread

SUPERCHARGER!

 

Anyone around ABQ have an SWR meter I could come by and borrow for a few minutes? I finally got most all of the parts in (haven't gotten one damn adapter yet!) for my CB setup, but I will need to tune it up.

I'm planning on installing everything this afternoon maybe, and could do today/tonight/any time Sunday, or even any time after 5pm next week.

 

Yes. I can drop it off somewhere. You can swing by as well but I may have to go run some errands later today. Let me know which one you prefer.

 

Call or text me when you're on the way so I know when to expect you.

 

The tent was great!

 

TacoIII your truck looks good. Saw you drivin east on Eubank on Thursday. That high clearance is so sweet and the tent and pack rack are mean. Expedition vehicle for sure.

 

I was wondering who that was. My girlfriend said I was being a creepo because i was staring and waving at you haha. you never looked

 

It's slowly coming along.

 

Hey all so who on the Westside has seen the full LT white extended cab 1st gen. Saw it at Southern and Unser a little earlier. Anybody have any ideas?????

 

I am interessted in a Wrench day or two.. but I need Sgt Taco's help on what I still need to order

 

I have two of the MOOG greasable ball joints

$27 K80811 Front Upper Suspension Ball Joint for Toyota Tacoma

K80811, one

$27 K80827 Detroit Axle - 2 Front Lower Ball Joints for 2005-2019 Toyota Tacoma Lower Ball Joint 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 Replacement

K80827 (so order one more

$24 Moog K80827 Front Lower Suspension Ball Joint for Toyota Tacoma

Moog K80827 balljoint) I have two OEM CV boot kits so your good there. Just will also need to get your tie rods.... I'm sure your wheel bearings and drive shaft bearing will need to be done soon but might as well wait till they start showing signs.

 

I am fairly new to TW and if I had known there was someone local I could give my business to I would have. I will come to you for future ideas.

 

Those Moogs good, SGT Taco? I am debating which brand to go with when I swap out mine. I have no indicators of bad BJs but since the Taco is at 127k I figure why not. And that entire prior sentence is Freud worthy.

 

Moog is good stuff

 

Hah, I just noticed your sig line about being the cooler decal guy

I need to hunt down that "bad Moog" thread I saw somewhere and ask the folks what their issues were.

 

I'm sure with the right amount of strain any BJ can break. Scott can tell you. He has personally handled the BJs.

 

I was tryin to slow down to get another glimpse of that high clearance sexiness.

 

Brakes and Rotors as well?

 

Most people's problems with moog is there tight tolerences during install or they forget they are non sealed and need to grease them...