1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

5100s installation instructions?

Discussion in 'Suspension' started by Lunercrab, Oct 19, 2008.

  1. Oct 19, 2008 at 1:38 PM
    #1
    Lunercrab

    Lunercrab [OP] Well-Known Member

    Joined:
    Feb 10, 2008
    Member:
    #4680
    Messages:
    758
    Gender:
    Female
    First Name:
    Beth
    Lehigh Valley area, PA
    Vehicle:
    2019 off road cement
    Anyone here have any installation instructions for the 5100s for the rear? I took off my rear shock today to install the 5100s, but I am a noob at this, and I'm a bit confused. I kinda figured where most of the rubber pieces and such go but I want the be sure. One more thing, is there a certain way to intall the shock, cause I did notice it was like 3-4 inches longer then the mounts allow. Am I supposed to compress it or something to get it to fit?
     
  2. Oct 19, 2008 at 2:01 PM
    #2
    chris4x4

    chris4x4 With sufficient thrust, pigs fly just fine. Moderator

    Joined:
    May 8, 2008
    Member:
    #6497
    Messages:
    112,751,520
    Gender:
    Male
    First Name:
    FlimFlubberJAM
    Tenoe, AZ
    Vehicle:
    2019 Rubicon 4 Door,
    4.10 gears, sliders, and lots of buttons.
    Yes, you need to compress it a bit. There is only one way for it to go into the truck. Shaft pointin up. :)
     

Products Discussed in

To Top