LSC15's 95 Tacoma 4x4

Go Back   Tacoma World Forums > Tacoma Garage > Suspension

Notices

Should the stock springs, insulators and mounts be sufficient to reuse?

Reply
 
Thread Tools Search this Thread Display Modes
Old 09-22-2011, 08:08 PM   #1
saugus [OP] saugus is offline
Senior Member
saugus is on a distinguished road
Joined: Sep 2011, #62820
Gender: Male
Posts: 340
saugus's Tacoma Gallery
Should the stock springs, insulators and mounts be sufficient to reuse?

Just got my Bilstein 4600 shocks for my 2006 5 lug. Is it safe to say that I should just be able to pop out the old front shocks and pop in the new ones? Or is it wise to replace parts like coil springs, mounts and insulators?

Also, shouldn't the front shocks have a rubber cushion absorber that sits in the tray of the shock where the bottom of the spring sits? I picture a lot of noise and friction. The service manual doesn't show one.
  Reply With Quote
Old 09-23-2011, 05:37 PM   #2
saugus [OP] saugus is offline
Senior Member
saugus is on a distinguished road
Joined: Sep 2011, #62820
Gender: Male
Posts: 340
saugus's Tacoma Gallery
I'll take the silence as a yes. I plan to start tomorrow.
  Reply With Quote
Reply


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
eibach springs vs. stock springs on billys 1 loud trd 2nd Gen. Tacomas 9 01-13-2011 08:13 PM
Spare Tire - Reuse T0y0ta05 2nd Gen. Tacomas 5 10-21-2010 12:25 PM
free downey skidplate, FS:SR5 springs, swaybar mounts/bushings, gtrotter Buy / Sell / Trade 0 04-28-2010 12:58 PM
Stock seats and mounts weshadowforth Buy / Sell / Trade 5 12-16-2009 05:34 AM
good bibs for cold weather hunting/ boot insulators too tacomaman06 Guns & Hunting 26 12-01-2008 10:48 PM


Copyright © 2014 Tacoma Forum. Tacoma World is not owned by, or affiliated with Toyota Motor Corporation.