OME top plate spacers

Holy rake Batman

What are your hub to fender measurements ?

 

Just an update, my back sits exactly 2 inches higher than my front...stock.

 

I never measured from the hub, but from the ground to the fender was 38 1/2 up front and 41 in the rear, give or take a 1/4 passenger to driver. It's not much more then the stock rake I had, and I don't mind it at all

 

Post your hub to fender measurements in my 2nd Gen Dakar Measurement thread

 

http://www.tacomaworld.com/forum/showthread.php?t=173193

 

not a real good pic but heres mine with the complete OME kit with Dakars in the rear and the top plate spacers with the 885's in the front:

 

Post in my Dakar thread

Link above

 

I have the same setup with the full darkars, nitros all round, and the 885s on my 2013 dbcb trd or. I got 23 from center hub to fender on the front, and 24.25 from center hub to fender on the back. I think its pretty close to stock rake. I had a shop do the install, and when I drove it home it was all crazy like yours, back end way up in the air even though the front was riding with 3.25 of lift from the fresh coils. I added a couple hundred pounds to the back, per the shop owners recommendation, and it settled right in a few days. He also recommended that I stop back shortly after 500 miles so he can check and tighten the u bolts on the darkars after settling.

 

Are you using the 885's or 884's?