Axle shims

You are installing Dakars , no ?

You need the collar , not a longer centre pin , the stock Dakar pin is long enough to add the collar .

See here http://www.tacomaworld.com/forum/suspension/144224-dakar-installation-axle-shims.html

 

ordered. Thank you so much for the help

 

Lolz

 

How would one go about fixing that, or knowing if its out of balance? I didn't mark the flange when I installed the Dakars and I have vibes. I plan on troubleshooting with axle shims this weekend, but I'd like to be aware of all potential culprits....

 

^^^^^^^

BassMaster , you didn't drop your driveshaft to install the dakars did you ?

 

I guess not, maybe I'm just bein parnoid. We definitely "dropped" down the rear axle, almost to the ground to put the leaf springs on, didn't disconnect the driveshaft or anything tho. Didn't mark or measure anything either. When I say dropped, i mean lowered down with a small floor jack, while the rest of the rear end was jacked up with a large floor jack. I guess we are talkin about different things...

 

If you didn't disconnect the driveshaft don't worry about it