Double checking with TW members

hey guys just had billies installed in the front of my truck. Set @1.75. I was gonna ride like this for a while since i was going to purchase maxtrac spindles and all pro leaf pack will be holding back on that for a while. So thinking of purchasing eibach coils from toytec to add to my billies to get 3" lift in the front. and 2" AAL.
just to make sure this is what i have planned to buy for my pre runner:
- Eibach coils to install in billies @ 1.75 for front 3" lift (lR uca's later down the road.
-Extended brake lines for the front
Rear AAL and with u bolts included. w rear billies 5125 shocks
- would i need extended brake lines for the rear too?

soooo am I missing something. for a temporary lift till my truck is ready for spindles.

 

Don't take me as right, but I don't think you need brake lines in both front or rear, the 5100's in the rear are fine, and you can't go past .85 with the Eibachs, so you should probably get a spacer lift to finish the 3". But then again I'm pretty wrote off when in comes to suspension, so wait for normal people to respond

 

i seen that too i think its like a 1/4 inch spacer but im not sure. yea hopefully somebody who has or done this set up can pitch in.

 

Well I just bought the Eibachs and the 1.5" 5th leafs myself to go with my 4 5100s so I would be pretty pissed if it doesn't work out for me lol

 

1.5 aal is tsb right? did you get extended brake lines?

 

No its not. Its the same as the 2" aal but for trucks WITH the TSB. I didn't order or ever hear of extended brake lines

 

You only need extended brake lines if you are lifting the rear 3" or more

 

Using full OME setup & dakars, fully flexed with stock brake lines & no issues.

 

sounds good. thanks for helping me save some money. so the highest you can billies with the eibach springs is @ .85?

 

Yes

 

Ya then 1/4" spacers give you another 1/2", or 1/2" spacers give you about 3/4". I'm probably just sticking with .85 and Eibachs though.