HELP asap with LR UCAs

So the shop just called me after installing the Eibachs/5100 at .85 and LR UCAs and apparently they said the alignment shop couldn't get the alignment right because they were too long of UCAs? Are they just stupid? Or is there a reason this could happen? I'm waiting for them to bring it somewhere else because I told them 1000's of people run that setup and are fine. Any quick thoughts?

 

GO TO A DIFFERENT SHOP......
WHAT SETTINGS DO YOU HAVE THEM ON

 

There should have been a print out that came with the ucas and it explains how they can adjust for different numbers. Show them it, then tell them the little engine that could didn't give up.

 

The shop installed them and sent them somewhere for alignment but now they are sending it somewhere else. There's very few shops here that can do that stuff though is the problem

 

Well as it turns out the majority of alingment shops have no clue how to do alingments

 

Well does anyone have the factor specs for one?

 

The alignment numbers everyone shoots for is 0, 0, 3 (camber, toe and caster respectively). I installed my UCAs at neutral position using only the extra 2 degrees built into the UCAs.

 

THIS IS WHAT SEEMS BEST FOR MOST PEOPLE.....
AND AS FOR THE SPEC SHEET I LOOK AROUND FOR YA ITS ON HERE

 

http://www.tacomaworld.com/forum/suspension/151843-lr-uca-install-help-2.html#post3297023

 

OH MR ENCLOPEDIA IS HERE

 

Here's a link to SPCs FAQs for these UCAs. Might be useful to take in

http://www.spcalignment.com/faq/article/25460_25470_25480_25490_toyota_adjustable_upper_control_arms

FYI, I wound up with 3.2 and 3.3 caster which is out of "spec". That is perfectly fine.

 

With 265's you'll be fine with that much caster. 285's will try to rip your body mounts off....

 

If they loosen the nut on top of the ball joint and move it in towards the motor in the slot, they become "shorter"...........they are clueless. +2 on taking it somewhere else. 0, 0, 2.4 ish.

 

Thanks guys. I will wait and see how it goes when they call me back

 

GIVE THEM MY # ILL TAKE TO THEM FOR YOU

 

Lol they still didn't call back so maybe they figured it out.

 

NO NEWS IS GOOD NEWS IN MY WORLD

 

Other shop couldn't either. Does anyone have the full printout of what to look for????