Maxtrac spindle with 4.75BS

Hi guys, Would this set up work without any issues? I'm planning on getting a 4" Maxtrac spindle + wheel with 4.75" BS and a 33x12.50x17 tire. I don't mind doing the plastic trimmings. Do I need a Cab mount chop aswell? thanks

 

bump

 

did you ever figure out if it fits?
thinking about doing the same with a 4.5 bs

 

https://www.tacomaworld.com/threads/maxtrac-spindle-lift-for-2nd-gen-prerunners.203889/
I posted your question here. Someone in this tread will have this answer

 

I'm going to go with you will rub quite a bit but I never ran that exact setup. I did maxtracs with 285's and 4" back spacing and rubbed a lot of plastic but not the cab mount.

 

Thank you hopefully someone answers! I was planning on going with a 4.5 bs too

 

I really just shared it for you. OP was 2 years ago