Mike "Wuzzy121". Rest in peace, brother

Go Back   Tacoma World Forums > Tacoma Garage > Suspension

Notices

Toytec/Eibach front coil lift springs

Reply
 
Thread Tools Search this Thread
Old 03-22-2010, 02:19 PM   #1
60guy [OP] 60guy is offline
BADASS
60guy is on a distinguished road
 
60guy's Avatar
Army: UH-60/C-12/RC-12 Pilot
Name: Dustin
Joined: Sep 2009, #22363
Location: Ohio/Texas
Age: 33
Gender: Dude
Posts: 170
60guy's Tacoma Gallery
Toytec/Eibach front coil lift springs

I have a 2010 DC 4x4 w/ the rear TSB and am looking to raise the front a little to match the back. Iím looking at Toytec/Eibach front coil lift springs with Bilstein 5100s set to 0.0. Toytecís website says this will give me about 1.6Ē of lift in the front which should level me out pretty good with the back being just slightly higher (which I want since I tow occasionally).
My question is does anyone have any experience with this set up??? Also is there anything else Iíll need to install such as a sway bar positioning clamps, front sway bar relocation kit, driveshaft carrier bearing drop kit or shims????

I put a lift on my 05 Tacoma, but it was a pre-runner and didnít have a front drive shat to worry about.

Thanks for the help!
  Reply With Quote
Old 03-22-2010, 04:35 PM   #2
Senior Member
nvdeserted is one of the sharper tools in the shednvdeserted is one of the sharper tools in the shednvdeserted is one of the sharper tools in the shednvdeserted is one of the sharper tools in the shednvdeserted is one of the sharper tools in the shednvdeserted is one of the sharper tools in the shednvdeserted is one of the sharper tools in the shednvdeserted is one of the sharper tools in the shednvdeserted is one of the sharper tools in the shednvdeserted is one of the sharper tools in the shednvdeserted is one of the sharper tools in the shed
 
nvdeserted's Avatar
Joined: Nov 2008, #11062
Location: Reno, NV
Gender: Male
Posts: 1,307
nvdeserted's Tacoma Gallery
At 1.6" you should be golden without any other stuff. The most you'll need is maybe an algnment after install.

Another option is to keep your factory coils, put them on the 5100's, and set the 5100's to the 1.75" setting... if you want to save a buck.
  Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Similar Threads
Thread Thread Starter Forum Replies Last Post
Where to buy Eibach coil springs (not Toytec)? KingMoo 2nd Gen. Tacomas 16 10-11-2011 05:09 PM
WTB: Eibach/Toytec lift springs SCSPerformance 1st Gen Tacoma Marketplace 0 09-06-2011 11:28 AM
Toytec/Eibach front coil lift springs /bilstein 5100 rayny1014 Buy / Sell / Trade 8 05-09-2011 10:14 AM
FS: Eibach Lift Springs w/ 5100s and ToyTec AAL NumNutz Buy / Sell / Trade 37 08-19-2010 07:06 PM
WTB Toytec/Eibach front coil lift springs Sky Buy / Sell / Trade 4 08-10-2010 02:53 AM


Copyright © 2014 Tacoma Forum. Tacoma World is not owned by, or affiliated with Toyota Motor Corporation.