CV angle pics- lmk what you think......

My CV angles were pretty good before with just my 884x springs. I wanted to correct my taco lean so I had the 1/4 in top plate spacer installed- man did I have some lean...big difference in bringing up the front drivers side. But since the spacer install my Cv angle got a little worse.

Take a look at the pics below, let me know what you think.....

If I am on level ground the last two fins in the pic that look like they touch are actually about 1/8-1/16" gap between them. But I can clearly see a ring rub mark on the fin, which leads me to believe they are rubbing while driving.

 

That's nothing There is a mod somewhere on here where you take the ring off the boot and put a pipeclamp on it so you can move the boot so it doesn't touch

 

Honestly that doesnt look bad at all and I wouldnt worry about it.