Need some lift answer before I buy my lift

Ok I think I found what I am going to do with my lift. Just concerned about the famous taco lean discussed inhere. Plan on buying AAL and 5100 for the front set to .85 or 1.75 not sure yet still need to measure the truck now sitting on level surface. Looks to sit really close to level now though. That I will figure out later and can go higher with blocks for the rear if need be. Question is would I have an issue with the lean or not? Seems like some do some don't.

Thanks for the honesty

 

If you are using the Bilstein 5100s with your factory coils, then you should not have any lean issues.

 

Alright I have a question now too. If I were to get 5100's for the front, I can set them to 2.5 using stock everything? Including coils? Thanks

 

Not exactly true in all cases. I have the 5100's / factory coils with the toytec spacer on the drivers side. I STILL have a slight lean. Also i have my 5100's set at .85 with the spring TSB. I have a very slight rake.