Bed X-tender Template

Just bought a used bed xtender online. Anyone know where I can get the template to mount the qucik release brackets? thanks

 

hey man i think i still have mine if you want me to send it to you

 

pm sent

 

Here you go....easily found online

http://www.toyotapart.com/2005-2010_TACOMA_BED_EXTENDER_PT329-35050_REV._A_--PT329-35050.pdf

 

Thanks Steve!
Says for 2005. Guessing this will fit a 2011? I think 2005 and newer are all the same. Would you guys put any sealant or glue on the screws when mounting the quick release brackets?


Thanks for the quick responses. Another reason why this sight is one excellent resource!

 

sry i re pmed you without seeing steve got you a template......

um i didnt put any sealant on. I dont think it's not necessary if you tighten screws well because the cover the holes completely. Also it is very tight against the d-pilars, therefore it wont trap water.

 

Subbed for later

 

Thanks guys! The xtender didn't come with brackets so I bought amp quick release brackets. Didn't get them yet but im sure they don't come with templates

 

I didn't put the sealant on mine and haven't had any issues.

 

I know the ones with toyota harware have a bolt and nut that you need to remove the tail lights to secure. seems a better, more sturdy app. I did install one on my older truck witht he self tappers and although they never came loose I was always afraid of them ripping out.

 

Just got the pdf file from Amp Research. It is the full instructions with templates. I will try and post it if I can or email to those who need it.

 

Update:
Installed the bed xtender today. You really cannot go by the template they provide. It is a good starting point but I had to raise it by about an inch to inch and a half, otherwise the xtender is not level. Best bet is to tape the template for a guide then adjust higher to make sure it's level, then reposition the template.