1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

URD MAF calibrator causing CEL.

Discussion in 'Technical Chat' started by HumboldtTaco707, Jul 19, 2012.

  1. Jul 19, 2012 at 8:45 PM
    #1
    HumboldtTaco707

    HumboldtTaco707 [OP] Well-Known Member

    Joined:
    Nov 4, 2011
    Member:
    #66466
    Messages:
    202
    Gender:
    Male
    Humboldt
    Vehicle:
    2006 4x4 Blackout
    Dynomax cat-back with super turbo muffler dumped before axle, JBA LT headers, rear fox shocks w/ piggyback, wet okoles, 1 10" square kicker, husky liners, URD short throw, URD maf calibrator
    I got my URD maf sensor calibrator installed today and when i picked it up the check engine light was on and it threw a code DTC-P0103. The guy said it was nothing to worry about and it might go away when the ecu adjusts. On my way home i noticed i had nooooooo power past 2.5k rpm and the throttle wouldnt engage past half-throttle. I called him back to see what could be wrong and it turns out he used quick connects and didnt solder. He says he will call gadget tomorrow n see what he has to say but i think he shouldve soldered. Anyone else get that code?
     

Products Discussed in

To Top