1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Finally got my hyperflash LED signals to calm down...

Discussion in 'Technical Chat' started by multiminpins, Nov 19, 2013.

  1. Nov 19, 2013 at 11:43 AM
    #1
    multiminpins

    multiminpins [OP] Member

    Joined:
    Sep 26, 2013
    Member:
    #113294
    Messages:
    13
    Gender:
    Male
    First Name:
    Bob
    Charlotte, NC
    Vehicle:
    '99 Tacoma SR5 4x4
    Bluetooth.
    Replaced all four turn signals with LED bulbs a couple years ago on my 1999 Tacoma. I read about problems with new flashers that didn't work, so I never ordered any. Today I finally found these photos and instructions, followed them and got it fixed. I'm not very good at electronic stuff, but I dug out the connection pictured and had success. I was fortunate that my flasher was an exact match to the one pictured.

    [​IMG][​IMG]

    Just took the point of my exacto knife and and drilled out the red spot on the pic until I could see under a magnifier that the connection was broken. Note that the pic on right is flipped from the one on the left.
     

Products Discussed in

To Top