1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Taco won't start after K&N install?

Discussion in 'Technical Chat' started by TacoOnfire, Sep 22, 2014.

  1. Sep 22, 2014 at 11:32 AM
    #1
    TacoOnfire

    TacoOnfire [OP] New Member

    Joined:
    Sep 22, 2014
    Member:
    #138858
    Messages:
    4
    Gender:
    Male
    If your Taco starts up and shuts down after the K&N install you need to make sure your mass air sensor is installed correctly as noted in the instructions, there's an opening on the bottom side of it that has to face towards the air intake filter, so that means the assembly should be facing the front of the truck,
    I did just that and it started one time with no problems after.
     
    Kleon94 likes this.

Products Discussed in

To Top