Squeaky Driveshaft.

I searched, couldn't find anything. I have a 2006 TRD Sport, sr5, PreRunner. I just finished adjusting the rear breaks so I had the driver side of the truck off the ground. Jackstand under the rear axle. Finished up and drove off. Breaks no longer squeal but no there's a sort of chirp from the driveshaft when it's under load. Forward or reverse. Speeds up as I speed up but as soon as I throw it in nuetral it stops. Got under the truck to look around and the chirping happens again just by twisting the shaft by hand. Any ideas? Thanks.

 

Grease the zerks first off, drive a hundred miles then report back.

 

Could you give me general locations so I don't miss any?

 

Generally when it sweaks in reverse its the U joints

 

A little off point, but does the drive shaft spin when driving in neutral?

 

OP u don't have any zerks to grease at all considering u have a prerunner.

 

There's still 1, no?

 

Not that I've ever found and he got my twin.

Nothing on the driveshaft or u joints for me

Stupid isn't it?

 

So where does that leave me? A U joint maybe?

 

OP.... You may want to verify whether or not you have grease zerks or not.

Use the information in this thread to determine whether or not you have grease zerks.
http://www.tacomaworld.com/forum/te...ntire-drive-shaft-u-joints-5-zerks-total.html

I have a 2007 and I have 6 zerks on my rear driveshaft alone.

 

Thanks, janster. I'll try to check them out tonight and update.