Delta00's 2002 Tacoma 4WD

Go Back   Tacoma World Forums > Tacoma Garage > Technical Chat

Notices

Brush Guard

Reply
 
Thread Tools Search this Thread
Old 03-30-2015, 08:41 PM   #1
RAHTacoma [OP] RAHTacoma is offline
Junior Member
RAHTacoma is on a distinguished road
 
RAHTacoma's Avatar
Army: C co 3/10 Mountain DUSTOFF(ETS)
Joined: May 2014, #129619
Location: Utah
Gender: Male
Posts: 6
RAHTacoma's Tacoma Gallery
Brush Guard

I picked up a cheap brush guard from a gentleman who didn't know what vehicle it would fit, I measured the distance between the mount arms at 38 inches and dimensions wise it seems to fit something similar to a tacoma. The attach arms are just 3 holes in a line, I am tempted to fabricate the vehicle brackets if the width is the same as one specific to a tacoma. Could someone measure their guards width at the attach points??

If it's the wrong size can anyone help Identify it, so I can order the correct brackets and sell it?

Only numbers stamped on the guard are:
DOP 130009922

  Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Similar Threads
Thread Thread Starter Forum Replies Last Post
Brush guard Grille Guard Kevinztaco 2nd Gen. Tacomas 13 08-19-2014 04:10 PM
Grill Guard / Brush Guard / Push Bar jrich44 1st Gen. Tacomas 0 09-16-2011 03:04 PM
Chrome or Black?? Bull Guard or Full Brush Guard?? HottyToddy 2nd Gen. Tacomas 20 04-23-2011 08:59 AM
brush guard/bull guard? DaytonLax14 Off-Roading & Trails 10 11-06-2009 08:10 PM
What grille guard/brush guard do you recommend? bacobits24 1st Gen. Tacomas 6 07-23-2008 11:59 PM


Copyright © 2015 Tacoma Forum. Tacoma World is not owned by, or affiliated with Toyota Motor Corporation.