1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

MOTOR SWAP

Discussion in 'Toyota Trucks & SUVs' started by CRC65, Oct 25, 2012.

  1. Oct 25, 2012 at 1:04 PM
    #1
    CRC65

    CRC65 [OP] New Member

    Joined:
    Oct 25, 2012
    Member:
    #89768
    Messages:
    1
    Gender:
    Male
    First Name:
    CLAY
    COLORADO
    Vehicle:
    07 TACO
    3IN LIFT,GRILL GAURD AND WINCH
    I PUT A 4.0 OUT OF A O8 FJ INTO MY 07 TACOMA EVERYTHING PLUGGED IN BUT NOW MY VVT NOT WORKING ANYONE HAVE ANY IDEAS
     
  2. Nov 26, 2012 at 1:47 AM
    #2
    RussellG

    RussellG Well-Known Member

    Joined:
    Nov 17, 2012
    Member:
    #91351
    Messages:
    192
    Gender:
    Male
    First Name:
    Russell
    Firestone
    Vehicle:
    87 DLX/00taco everything except the FJ bits
    Diamond Axle SAS, TRD FJ calipers and brembo rotors on all 4, FJ rear axle, 5.29's and elockers in both, 3rz swap and dual cases,4.7 rear case,00 taco dash, bobbed bed,soft topper,raceline beadlocks, fj cruiser steering wheel and clinometer, super white paint and 37'' kevlars. Much more but i will keep it simple.
    What harness did you use? If you just plugged in the Fj engine harness to the taco ecu then you could have something as stupid as 1 wire be differet. I don't have both diagrams in front of me but I'd say you should have put your wiring on the Fj motor and used your acc stuff to insure no issues.
     

Products Discussed in

To Top