Last Updated: 9/23/14
Gibson Exhaust Performance Header made by Gibson

Reviews Exhaust Performance Header Reviews & Discussions:

"Curretly sittin on Gibson Cat-back Bilstein 5100ʻs set at 2.5 2 1/2 inch Add a Leaf in the rear (5100ʻs) 1/4 top plate 265/75R16 Duratrac on stockies I really enjoy a good Off-Roading session. The videos are short..."

Posted on 09-23-2014, 02:07 AM

"Put on the gibson cat back exhaust system because my stock exhaust and tail pipe rusted out. It sounds perfect! but my driver side inner CV looked rough while i was under the truck. There was no tears but you could tell..."

Posted on 09-04-2014, 01:16 PM

"Yes, I did run LCE header with oem midpipe/cats & oem catback. The Gibson catback went on last."

Posted on 08-19-2014, 02:49 PM

""butt dyno". Nice (lol)! :burnrubber: If I read your response correctly, you ran stock with the header and catback, then changed out to the LCE header and Gibson catback? Was there a time you ran the LCE header with the oem catback?"

Posted on 08-19-2014, 01:43 PM

"2nd gen here but running 2.7 with LCE with oem catted midpipe and Gibson catback. The pipe is bigger diameter on catback. I did run it for awhile with oem catback/header and changing the catback only changed the sound but didn't notice that it freed up any"

Posted on 08-19-2014, 10:14 AM

"I stayed pretty busy today, installed my AVID bolt on sliders, debadged my tailgate and put on a TRD Baja emblem, and finally threw my Gibson catback exhaust on. Big shoutout to Brandon over at AVID Offroad for the excellent customer service. He even had a"

Posted on 08-02-2014, 07:36 PM

"Well I had a buddy of mine I thought i could trust install a gibson cat back on my 2013 Tacoma. I drove about 15 miles before i realized something didn't feel right, when i got out and inspected the exhaust i found out he installed it backwards. Could this"

Posted on 08-01-2014, 06:19 PM

"MAF with the harness already spliced into so that should be plugnplay whenever I get around to trying to tune mine. It'll be trial and error since Gadget says no maps for LCE header/Tooter IM spacer/Gibson catback/KVA intake combo. Will need 3rd bung welde"

Posted on 07-09-2014, 08:37 AM

"Gibson cat-back for sale. Fits 1st gen extended cab. 150 OBO"

Posted on 07-05-2014, 01:54 PM

"up higher in the RPM range. Does the same concept apply with a TRD cat back exhaust? Or does the low end torque stay the same with the TRD cat back system. Also does anyone have experience with the Gibson cat back exhaust?"

Posted on 07-05-2014, 01:21 PM