Last Updated: 4/24/15
Extang FullTilt Tonneau Cover made by Extang

Reviews FullTilt Tonneau Cover Reviews & Discussions:

"Mine leaked a lot. I went back to using an Extang full tilt tonno. Not quite as cool, but pretty functional."

Posted on 01-17-2015, 05:32 PM

"I thank you all for any suggestions! That Extang Full tilt is nice! Any advice on spray on bed liner just throwing in a bed mat?"

Posted on 11-05-2014, 09:31 AM

"I had the extang full tilt which was the best of both worlds. Tilted up like a fiberglass top or could roll back like a traditional cover or take off the whole top easily."

Posted on 11-05-2014, 08:40 AM

"I have the extang full tilt which is nice cause you can just lift it up like a hard cover or take it off completly."

Posted on 08-18-2014, 05:28 AM

"I had an Extang FullTilt Tonneau Cover on one of my previous trucks, a '00 Dodge Dakota. Had it 7 years and it looked good when I sold the truck. If I was in the market for a soft cover, I would buy an Extang."

Posted on 08-11-2014, 08:14 PM

"I have the extang full tilt cover which tilts up like a hard cover . This way your not constantly undoing your snaps or if you want to take it off you can."

Posted on 03-04-2014, 08:25 AM

"I agree, that cover in the pics is very narrow. My Extang Full Tilt covers at least half of the bed rails, if not two thirds, and stays very dry in any amount of rain. When I go through an automatic pressure wash, I'll get a little bit of water around the "

Posted on 02-18-2014, 11:35 AM

"area where they are constantly folded wearing out after several years of use on some brands. If you go with a roll-up, look into one that will open up like a trunk or roll-up if you want, like the Extang Full Tilt, it gives you two options to open it. This"

Posted on 02-18-2014, 07:59 AM

"Extang full tilt"

Posted on 12-26-2013, 03:41 PM

"I had a Pace Edwards. I liked the look, but it leaked pretty much. I replaced it with a Extang Full Tilt. Not as pretty, but pretty water tight and it does not consume a lot of space."

Posted on 11-07-2013, 07:41 PM