What Have You Done To Your 2nd Gen Tacoma Today?

Lol! I went big. Make sure to get the backing plate because that's what actually fits in the oval that the regular Toyota emblem sits in. The Model T mounts to the backing plate and then the plate screws to the grill.

Here's the March thread. Seems like he can only make them certain times of the year: http://www.tacomaworld.com/forum/diaz-fabrication/318417-2014-march-batch-devil-horns-model-t.html

 

Diff breather relocate. Piece 'o cake.

 

Thanks! I'll add it to my to-do list

 

Painted my fucking wheel weights!

 

Installed my bestop!

 

Got 2 wheels painted yesterday and put them back on this morning, then pulled the rears and got most of the prep done. Will spray them tomorrow. I'm really happy with how they turned out.

 

Pretty good day for the truck. Spidertrax installed and made a console organizer.

 

replaced front, rear, and transfer case oil. greased driveshaft, cleaned MAF sensor and throttle body. Already noticed a huge difference in throttle response. Put on new brake pads. and I put back on my sway bar which helped a lot, not sure why I kept it off lol.

 

I finally got around to drilling out the holes and mounting my MOLLE panel. I also trimmed down the plastic bin that I pulled out in order to protect the JBL Sub/Amp. It is a little rough looking, but I am happy with the outcome. I plan to powder coat the panel and will likely paint the JBL cover too.

 

Replaced cabin and engine air filter

 

Fog housings installed.

 

Easy job but few do it!

 

lol

 

Very nice, but do they turn on and off?

 

Wired up my map lights to come on when the door is opened like the dome light

 

Link to write up?

 

http://www.tacomaworld.com/forum/2nd-gen-tacomas/251261-map-lights-dome-light.html

 

Cool thanks +1

 

Where did you get this done at?

 

Amen. Do they look flatter on top on the long beds? The short beds seem to angle up in the middle a lot