Front end needs more lift?

I have a Toytec lift 3" kit with rear add a leaf. I notice that the front doesn't sit as high as the rear and this bothers me, I like the completely level look. What can I do to make this thing sit level? I figured I would ask here as I would like to do something once and be done instead of trying different things on my own. I attached the best picture I have that shows what I am talking about.

 

lower the rear with a smaller add a leaf,,, or add some weight in bed for awhile to get the rear to sag a bit

but do not add more lift to the front

 

Isn't that what a leveling kit is for?

 

Go for it add more then 3 to the front ,see how many more problems he compounds

 

What are your measurements from center of Hub to fender?
Looks pretty level to me, looks good

 

I know little about lifts and suspension so you're probably right!

 

I have the shim in the rear that came with the kit, if I remove that it would lower the rear a little bit and I have read on here of people not using the shim. I don't want to throw off my drive line angles and have any vibrations though???

 

22.5- front
24- rear

 

I'm sitting a 23" front and back center hub to wheel well. I have bilstein 5100s all around with a wheelers aal and OME 886 springs up front. Not sure what your kit all came with.

 

Is the overload leaf still in the pack? If it is take it out and you're down a 1/2" in back.

 

I had this same problem when I put in my OME lift. I put in 1/2 in top plate spacers and it leveled it right out. didn't notice any difference in ride either.