Thoughts on 37s

I run the BBs and I love them. No vibes anywhere really. Not that I notice anyway. Make sure you don't get the biodegradable ones though. Supposedly they'll disintegrate due to moisture.

 

I was thinking about using steel or copper BBs instead of the airsoft ones. I figured the denser, smaller BB might work better.

 

I used 7oz in my 35s on diy beadlocks and had a little vibrations at 45 other than that she was smooth sailing. I'll probably put 8oz in the tsls

 

We're you using airsoft or steel BBs?

 

This is what I used in my 36 Irok's http://www.counteractbalancing.com

 

Air soft

 

Rotated my tires and had a slight rub between my wheel and caliper afterwards. So I ground the caliper a hair more. Only got to drive a few miles afterwards but the vibration seemed to be significantly less.

Dunno...we'll see what happens over the course of the next week

 

Got the driver side finished up, haven't got a final finished picture because I was rushing to finish up, I will get some tomorrow though

 

Wow!!! Thats a big hole.... Little tricky around the wiring?

 

Don't pull a bulhas and burn up your entire dash

 

Not really I just took a shot to calm my nerves and then just took out little by little until I could move it out of my way

 

It's already done and luckily only small fires when I welded the sheet metal on.

 

That seem sealer is flammable as fuck. It's important to have someone in the cab with a wet towel to put out flame ups during welding. If you just start welding the truck may burn before you finish

 

I cut out around it and cleaned up around the areas I was going to weld to prevent that

 

Get those photos yet Levi?

 

Finishing the last two beadlocks as I'm typing

 

bitchin

 

That is one mean taco!

 

Or you could just skip right to 39.5's