All Pro HD Slider install advice

I've finally set to installing my All-Pro HD bold-on sliders, with the passenger side successfully installed at this point using just the existing frame holes, so I can mark the rest of the holes for drilling. I started doing the same on the driver side only to find that the pre-drilled holes in the frame appear to be those used for the brake line plastic clips.

The All-Pro instructions clearly state that pre-drilled holes are part of the installation:

"You will use the remainder of the Hex Head bolts to hold the plate of the slider to the frame in already pre-drilled holes in the frame"

I'm looking for guidance from those that have these installed - what did you do with those clips? drilling holes there would not work as it'll put a bolt and nut right into the brake lines.

Thanks,
-Ed

 

I emailed you, Ed.

Best regards,

Tracy
tracy@allprooffroad.com

 

Thanks Tracy - got your email, and was just reading https://www.tacomaworld.com/threads/bolt-on-rock-sliders-and-brake-lines.326485/#post-8573258 to see what others had done. Looks like the solution you mentioned in your message to me would welcomed!